-
Finite-size spherical particles in a square duct flow of an elastoviscoplastic fluid: an experimental study
Authors:
Sagar Zade,
Tafadzwa John Shamu,
Fredrik Lundell,
Luca Brandt
Abstract:
The present experimental study addresses the flow of a Yield Stress Fluid with some elasticity (Carbopol gel) in a square duct. The behaviour of two fluids with lower and higher yield stress is investigated at multiple Reynolds numbers $Re^* \in$ (1, 200) and Bingham numbers $Bi \in$ (0.01, 0.35). A secondary flow consisting of eight vortices is observed to recirculate the fluid from the corners t…
▽ More
The present experimental study addresses the flow of a Yield Stress Fluid with some elasticity (Carbopol gel) in a square duct. The behaviour of two fluids with lower and higher yield stress is investigated at multiple Reynolds numbers $Re^* \in$ (1, 200) and Bingham numbers $Bi \in$ (0.01, 0.35). A secondary flow consisting of eight vortices is observed to recirculate the fluid from the corners to the core. Their extent and intensity grows with increasing $Re^*$. The second objective of this study is to explore the change in flow in the presence of particles. Almost neutrally-buoyant finite-size spherical particles with duct height, $2H$, to particle diameter, $d_p$, ratio of 12 are used at two volume fractions $φ$ = 5 and 10\%. Particle Tracking Velocimetry (PTV) is used to measure the velocity of these refractive-index-matched spheres, and PIV to extract the fluid velocity. Simple shadowgraphy is also used for qualitatively visualising the development of the particle distribution along the streamwise direction. The particle distribution pattern changes from being concentrated at the four corners, at low flow rates, to being focussed along a diffused ring between the center and the corners, at high flow rates. The presence of particles induces streamwise and wall-normal velocity fluctuations in the fluid phase; however, the primary Reynolds shear stress is still very small compared to turbulent flows. The size of the plug in the particle-laden cases appears to be smaller than the corresponding single phase cases. Similar to Newtonian fluids, the friction factor increases due to the presence of particles, almost independently of the suspending fluid matrix. Interestingly, predictions based on an increased effective suspension viscosity agrees quite well with the experimental friction factor for the concentrations used in this study.
△ Less
Submitted 17 May, 2019;
originally announced May 2019.
-
Turbulence modulation by finite-size spherical particles in Newtonian and viscoelastic fluids
Authors:
Sagar Zade,
Fredrik Lundell,
Luca Brandt
Abstract:
We experimentally investigate the influence of finite-size spherical particles in turbulent flows of a Newtonian and a drag reducing viscoelastic fluid at varying particle volume fractions and fixed Reynolds number. Experiments are performed in a square duct at a Reynolds number $Re_{2H}$ of nearly $1.1\times10^4$, Weissenberg number $Wi$ for single-phase flow is between 1-2 and results in a drag-…
▽ More
We experimentally investigate the influence of finite-size spherical particles in turbulent flows of a Newtonian and a drag reducing viscoelastic fluid at varying particle volume fractions and fixed Reynolds number. Experiments are performed in a square duct at a Reynolds number $Re_{2H}$ of nearly $1.1\times10^4$, Weissenberg number $Wi$ for single-phase flow is between 1-2 and results in a drag-reduction of 43% compared to a Newtonian flow (at the same $Re_{2H}$). Particles are almost neutrally-buoyant hydrogel spheres having a density ratio of 1.0035$\pm$0.0003 and a duct height ${2H}$ to particle diameter $d_p$ ratio of around 10. We measure flow statistics for four different volume fractions $φ$ namely 5, 10, 15 and 20% by using refractive-index-matched Particle Image Velocimetry (PIV). For both Newtonian Fluid (NF) and Viscoelastic Fluid (VEF), the drag monotonically increases with $φ$. For NF, the magnitude of drag increase due to particle addition can be reasonably estimated using a concentration dependent effective viscosity for volume fractions below 10%. The drag increase is, however, underestimated at higher $φ$. For VEF, the absolute value of drag is lower than NF but, its rate of increase with $φ$ is higher. Similar to particles in a NF, particles in VEF tend to migrate towards the center of the duct and form a layer of high concentration at the wall. Interestingly, relatively higher migration towards the center and lower migration towards the walls is observed for VEF. The primary Reynolds shear stress reduces with increasing $φ$ throughout the duct height for both types of fluid.
△ Less
Submitted 28 November, 2018;
originally announced November 2018.
-
Buoyant finite-size particles in turbulent duct flow
Authors:
Sagar Zade,
Walter Fornari,
Fredrik Lundell,
Luca Brandt
Abstract:
Particle Image Velocimetry (PIV) and Particle Tracking Velocimetry (PTV) have been employed to investigate the dynamics of finite-size spherical particles, slightly heavier than the carrier fluid, in a horizontal turbulent square duct flow. Interface resolved Direct Numerical Simulations (DNS) have also been performed with the Immersed Boundary Method (IBM) at the same experimental conditions, bul…
▽ More
Particle Image Velocimetry (PIV) and Particle Tracking Velocimetry (PTV) have been employed to investigate the dynamics of finite-size spherical particles, slightly heavier than the carrier fluid, in a horizontal turbulent square duct flow. Interface resolved Direct Numerical Simulations (DNS) have also been performed with the Immersed Boundary Method (IBM) at the same experimental conditions, bulk Reynolds number $Re_{2H}$ = 5600, duct height to particle size ratio $2H/d_p$ = 14.5, particle volume fraction $Φ$ = 1% and particle to fluid density ratio $ρ_p/ρ_f$ = 1.0035. A good agreement has been observed between experiments and simulations in terms of the overall pressure drop, concentration distribution and turbulent statistics of the two phases. Additional experimental results considering two particle sizes, $2H/d_p$ = 14.5 and 9 and multiple $Φ$ = 1, 2, 3, 4 and 5% are reported at the same $Re_{2H}$. The pressure drop monotonically increases with the volume fraction, almost linearly and nearly independently of the particle size for the above parameters. However, despite the similar pressure drop, the microscopic picture, the fluid velocity statistics, differs significantly with the particle size. This one-to-one comparison between simulations and experiments extends the validity of interface resolved DNS in complex turbulent multiphase flows and highlights the ability of experiments to investigate such flows in considerable details, even in regions where the local volume fraction is relatively high.
△ Less
Submitted 28 November, 2018;
originally announced November 2018.
-
Turbulent duct flow with polymers
Authors:
Armin Shahmardi,
Sagar Zade,
Mehdi N. Ardekani,
Rob J. Poole,
Fredrik Lundell,
Marco Edoardo Rosti,
Luca Brandt
Abstract:
We have performed direct numerical simulation of the turbulent flow of a polymer solution in a square duct, with the FENE-P model used to simulate the presence of polymers. First, a simulation at a fixed moderate Reynolds number is performed and its results compared with those of a Newtonian fluid to understand the mechanism of drag reduction and how the secondary motion, typical of the turbulent…
▽ More
We have performed direct numerical simulation of the turbulent flow of a polymer solution in a square duct, with the FENE-P model used to simulate the presence of polymers. First, a simulation at a fixed moderate Reynolds number is performed and its results compared with those of a Newtonian fluid to understand the mechanism of drag reduction and how the secondary motion, typical of the turbulent flow in non-axisymmetric ducts, is affected by polymer additives. Our study shows that the Prandtl's secondary flow is modified by the polymers: the circulation of the streamwise main vortices increases and the location of the maximum vorticity move towards the center of the duct. In-plane fluctuations are reduced while the streamwise ones are enhanced in the center of the duct and dumped in the corners due to a substantial modification of the quasi-streamwise vortices and the associated near-wall low- and high-speed streaks; these grow in size and depart from the walls, their streamwise coherency increasing. Finally, we investigated the effect of the parameters defining the viscoelastic behavior of the flow and found that the Weissenberg number strongly influences the flow, with the cross-stream vortical structures growing in size and the in-plane velocity fluctuations reducing for increasing flow elasticity.
△ Less
Submitted 15 October, 2018;
originally announced October 2018.
-
Experimental investigation of turbulent suspensions of spherical particles in a square duct
Authors:
Sagar Zade,
Pedro Costa,
Walter Fornari,
Fredrik Lundell,
Luca Brandt
Abstract:
We report experimental observations of turbulent flow with spherical particles in a square duct. Three particle sizes namely: $2H/d_{p}$ = 40, 16 and 9 ($2H$ being the duct full height and $d_{p}$ being the particle diameter) are investigated. The particles are nearly neutrally-buoyant with respect to the suspending fluid. Refractive Index Matched - Particle Image Velocimetry is used for fluid vel…
▽ More
We report experimental observations of turbulent flow with spherical particles in a square duct. Three particle sizes namely: $2H/d_{p}$ = 40, 16 and 9 ($2H$ being the duct full height and $d_{p}$ being the particle diameter) are investigated. The particles are nearly neutrally-buoyant with respect to the suspending fluid. Refractive Index Matched - Particle Image Velocimetry is used for fluid velocity measurement even at the highest particle volume fraction (20%) and Particle Tracking Velocimetry for the particle velocity statistics for the flows seeded with particles of the two largest sizes, whereas only pressure measurements are reported for the smallest particles. Settling effects are seen at the lowest bulk Reynolds number $Re_{2H}\approx$ 10000 whereas, at the highest $Re_{2H}\approx$ 27000, particles are in almost full suspension. The friction factor of the suspensions is found to be significantly larger than that of single-phase duct flow at the lower $Re_{2H}$ investigated; however, the difference decreases when increasing the flow rate and the total drag approaches the values of the single phase flow at the higher Reynolds number considered. The pressure drop is found to decrease with the particle diameter for volume fractions lower than $φ$ = 10% for nearly all $Re_{2H}$. However, at the highest volume fraction $φ$ = 20%, we report a peculiar non-monotonic behavior: the pressure drop first decreases and then increases with increasing particle size. The decrease of the turbulent drag with particle size at the lowest volume fractions is related to an attenuation of the turbulence. The drag increase for the two largest particle sizes at $φ$ = 20%, however, occurs despite this large reduction of the turbulent stresses, and it is therefore due to significant particle-induced stresses.
△ Less
Submitted 18 September, 2018;
originally announced September 2018.
