Dedicated beam position monitor pair for model-independent lattice characterization at NSLS-II
Authors:
Yongjun Li,
Kiman Ha,
Danny Padrazo,
Bernard Kosciuk,
Belkacem Bacha,
Michael Seegitz,
Robert Rainer,
Joseph Mead,
Xi Yang,
Yuke Tian,
Robert Todd,
Victor Smaluk,
Weixing Cheng
Abstract:
This paper reports recent lattice characterization results obtained at the National Synchrotron Light Source II (NSLS-II) storage ring, conducted without reliance on a lattice model. A pair of beam position monitors (BPMs) with bunch-by-bunch (B$\times$B) resolution, were recently installed in a section of the storage ring free of magnetic fields. The new BPM pair measured the beam, or bunch's tra…
▽ More
This paper reports recent lattice characterization results obtained at the National Synchrotron Light Source II (NSLS-II) storage ring, conducted without reliance on a lattice model. A pair of beam position monitors (BPMs) with bunch-by-bunch (B$\times$B) resolution, were recently installed in a section of the storage ring free of magnetic fields. The new BPM pair measured the beam, or bunch's transverse Poincaré map precisely after the beam was excited. Linear one-turn-matrices (OTM) were then derived, and from these, the 4-dimensional coupled Twiss parameters were extracted at the locations of the BPM pair. By normalizing beam oscillation amplitudes with the Twiss parameters, the global action-variables were obtained. These action-variables facilitated the measurement of the local Twiss parameters observed by other BPMs independent on lattice model. This method is general, and particularly useful in certain scenarios such as a round beam mode in a diffraction-limited light source ring. We applied it to assess both weakly and strongly coupled lattices at the NSLS-II ring. Through analysis of the strongly coupled lattice, the quadrupole tilt errors were estimated to be less than 400 \siμrad. Utilizing the BPMs' B$\times$B resolution, for the first time we observed the variations of the linear lattice along a long bunch-train.
△ Less
Submitted 24 June, 2024;
originally announced June 2024.
Design and Operation of Front-End Electronics for the HERA-B Muon Detector
Authors:
M. Buchler,
W. Funk,
A. Gutierrez,
R. F. Harr,
P. E. Karchin,
P. Liu,
S. Nam,
J. G. Shiu,
S. F. Takach,
M. Atiya,
D. Padrazo,
A. Arefiev,
S. Barsuk,
F. Khasanov,
L. Laptin,
V. Tchoudakov,
I. Tichimirov,
M. Titov,
Y. Zaitsev
Abstract:
We have implemented a cost-effective design for the readout electronics of both the anode wires and the cathode pads of large area proportional wire chambers for the HERA-B muon system based on the ASD-08 integrated circuit. To control and monitor the large number of readout channels, we have built a distributed control system based on Philips Semiconductors' I2C bus and microcontrollers. To dat…
▽ More
We have implemented a cost-effective design for the readout electronics of both the anode wires and the cathode pads of large area proportional wire chambers for the HERA-B muon system based on the ASD-08 integrated circuit. To control and monitor the large number of readout channels, we have built a distributed control system based on Philips Semiconductors' I2C bus and microcontrollers. To date we have installed about 10800 channels of muon chambers and electronics. The average single channel noise occupancy is less than 10**-5, and the detectors have been operated with target interaction rates as high as 70 MHz.
△ Less
Submitted 10 December, 1998;
originally announced December 1998.
