-
Graphene as Infrared Light Sensor Material
Authors:
Ahalapitiya H. Jayatissa,
Madhav Gautam
Abstract:
The infrared (IR) photoresponse of graphene synthesized by an atmospheric chemical vapor deposition (CVD) system using a mixture of hydrogen and methane gases was studied. The IR sensor devices were fabricated using graphene films transferred onto a SiO2 substrate by a lift-off process. The quality of graphene was investigated with Raman spectroscopy and optical microscopy. The photoresponse was r…
▽ More
The infrared (IR) photoresponse of graphene synthesized by an atmospheric chemical vapor deposition (CVD) system using a mixture of hydrogen and methane gases was studied. The IR sensor devices were fabricated using graphene films transferred onto a SiO2 substrate by a lift-off process. The quality of graphene was investigated with Raman spectroscopy and optical microscopy. The photoresponse was recorded under the illumination of IR light of wavelength 850 nm and intensity of around 0.216 mW/cm^2. The effects of temperature and hydrogenation on photoconductivity were also studied. It was found that the transient response and recovery times decreased with the temperature increase. The hydrogenation effect also caused a significant decrease in the photoresponse of the device. Although the net change in the photoresponse for IR light was lower at low illumination intensity levels, the transient responses were observed around 100 times faster than the recently reported CNT-based IR sensors.
△ Less
Submitted 20 January, 2023;
originally announced January 2023.
-
Classification of events from $α$-induced reactions in the MUSIC detector via statistical and ML methods
Authors:
Krishnan Raghavan,
Melina L. Avila,
Prasanna Balaprakash,
Heshani Jayatissa,
Daniel Santiago-Gonzalez
Abstract:
The Multi-Sampling Ionization Chamber (MUSIC) detector is typically used to measure nuclear reaction cross sections relevant for nuclear astrophysics, fusion studies, and other applications. From the MUSIC data produced in one experiment scientists carefully extract an order of $10^3$ events of interest from about $10^{9}$ total events, where each event can be represented by an 18-dimensional vect…
▽ More
The Multi-Sampling Ionization Chamber (MUSIC) detector is typically used to measure nuclear reaction cross sections relevant for nuclear astrophysics, fusion studies, and other applications. From the MUSIC data produced in one experiment scientists carefully extract an order of $10^3$ events of interest from about $10^{9}$ total events, where each event can be represented by an 18-dimensional vector. However, the standard data classification process is based on expert-driven, manually intensive data analysis techniques that require several months to identify patterns and classify the relevant events from the collected data. To address this issue, we present a method for the classification of events originating from specific $α$-induced reactions by combining statistical and machine learning methods that require significantly less input from the domain scientist, relative to the standard technique.
We applied the new method to two experimental data sets and compared our results with those obtained using traditional methods. With few exceptions, the number of events classified by our method agrees within $\pm20\%$ with the results obtained using traditional methods. With the present method, which is the first of its kind for the MUSIC data, we have established the foundation for the automated extraction of physical events of interest from experiments using the MUSIC detector.
△ Less
Submitted 6 April, 2022;
originally announced April 2022.
-
In-flight production of an isomeric beam of $^{16}$N
Authors:
C. R. Hoffman,
T. L. Tang,
M. Avila,
Y. Ayyad,
K. W. Brown,
J. Chen,
K. A. Chipps,
H. Jayatissa,
B. P. Kay,
C. Müller-Gatermann,
H. J. Ong,
J. Song,
G. L. Wilson
Abstract:
An in-flight beam of $^{16}$N was produced via the single-neutron adding ($d$,$p$) reaction in inverse kinematics at the recently upgraded Argonne Tandem Linear Accelerator System (ATLAS) in-flight system. The amount of the $^{16}$N beam which resided in its excited 0.120-MeV $J^π=0^-$ isomeric state (T$_{1/2}\approx5$ $μ$s) was determined to be 40(5)% at a reaction energy of 7.9(3) MeV/$u$, and 2…
▽ More
An in-flight beam of $^{16}$N was produced via the single-neutron adding ($d$,$p$) reaction in inverse kinematics at the recently upgraded Argonne Tandem Linear Accelerator System (ATLAS) in-flight system. The amount of the $^{16}$N beam which resided in its excited 0.120-MeV $J^π=0^-$ isomeric state (T$_{1/2}\approx5$ $μ$s) was determined to be 40(5)% at a reaction energy of 7.9(3) MeV/$u$, and 24(2)% at a reaction energy of 13.2(2) MeV/$u$. The isomer measurements took place at an experimental station $\approx30$ m downstream of the production target and utilized an Al beam-stop** foil and a HPGe Clover detector. Composite $^{16}$N beam rate determinations were made at the experimental station and the focal plane of the Argonne in-flight radioactive ion-beam separator (RAISOR) with Si $Δ$E-E telescopes. A Distorted Wave Born Approximation (DWBA) approach was coupled with the known spectroscopic information on $^{16}$N in order to estimate the relative $^{16}$N isomer yields and composite $^{16}$N beam rates. In addition to the observed reaction-energy dependence of the isomer fraction, a large sensitivity to angular acceptance of the recoils was also observed.
△ Less
Submitted 15 April, 2022; v1 submitted 27 January, 2022;
originally announced February 2022.
-
Zinc Oxide-Based Piezoelectric Pressure Sensor
Authors:
Victor K. Samoei,
Ahalapitiya H. Jayatissa
Abstract:
This paper reports the application of zinc oxide (ZnO) in the pressure sensors that can be integrated with a microelectromechanical system (MEMS). ZnO is one of the materials that has received a great deal of attention due to its unique properties of being a semiconductor with wide bandgap and piezoelectric effects. The simpler crystal growth mechanisms of ZnO have resulted in a lower cost of ZnO-…
▽ More
This paper reports the application of zinc oxide (ZnO) in the pressure sensors that can be integrated with a microelectromechanical system (MEMS). ZnO is one of the materials that has received a great deal of attention due to its unique properties of being a semiconductor with wide bandgap and piezoelectric effects. The simpler crystal growth mechanisms of ZnO have resulted in a lower cost of ZnO-based sensors. Different types of pressure sensors based on ZnO sensing elements have also been explored. A thin circular ZnO film was simulated as a piezoelectric sensor employing the finite element method in COMSOL. The pressure applied on the thin film surface was varied and a boundary point probe was used to study the displacement field and voltage at the center of the membrane. The displacement field and voltage induced by pressure vary linearly with increasing pressure on the ZnO layer. Also. the method used in this paper was applied to different piezoelectric materials, such as barium titanate (BaTiO3), polyvinylidene fluoride (PVDF), and gallium arsenide (GaAs) that were studied by other groups, and similar conclusions were made. These simulations can be used in the design of piezoelectric sensors and the optimization of the sensitivity and performance of the materials used in pressure sensor applications.
△ Less
Submitted 22 October, 2021;
originally announced October 2021.
-
Texas Active Target (TexAT) detector for experiments with rare isotope beams
Authors:
E. Koshchiy,
G. V. Rogachev,
E. Pollacco,
S. Ahn,
E. Uberseder,
J. Hooker,
J. Bishop,
E. Aboud,
M. Barbui,
V. Z. Goldberg,
C. Hunt,
H. Jayatissa,
C. Magana,
R. O'Dwyer,
B. T. Roeder,
A. Saastamoinen,
S. Upadhyayula
Abstract:
The TexAT (Texas Active Target) detector is a new active-target time projection chamber (TPC) that was built at the Cyclotron Institute Texas A$\&$M University. The detector is designed to be of general use for nuclear structure and nuclear astrophysics experiments with rare isotope beams. TexAT combines a highly segmented Time Projection Chamber (TPC) with two layers of solid state detectors. It…
▽ More
The TexAT (Texas Active Target) detector is a new active-target time projection chamber (TPC) that was built at the Cyclotron Institute Texas A$\&$M University. The detector is designed to be of general use for nuclear structure and nuclear astrophysics experiments with rare isotope beams. TexAT combines a highly segmented Time Projection Chamber (TPC) with two layers of solid state detectors. It provides high efficiency and flexibility for experiments with low intensity exotic beams, allowing for the 3D track reconstruction of the incoming and outgoing particles involved in nuclear reactions and decays.
△ Less
Submitted 10 February, 2020; v1 submitted 18 June, 2019;
originally announced June 2019.
