-
Development of the photo-diode subsystem for the HERD calorimeter double-readout
Authors:
O. Adriani,
M. Antonelli,
A. Basti,
E. Berti,
P. Betti,
G. Bigongiari,
L. Bonechi,
M. Bongi,
V. Bonvicini,
S. Bottai,
P. Brogi,
G. Castellini,
C. Checchia,
J. Casaus,
X. Cui,
Y. Dong,
R. D'Alessandro,
S. Detti,
F. Giovacchini,
N. Finetti,
P. Maestro,
P. S. Marrocchesi,
X. Liu,
J. Marin,
G. Martinez
, et al. (18 additional authors not shown)
Abstract:
The measurement of cosmic-ray individual spectra provides unique information regarding the origin and propagation of astro-particles. Due to the limited acceptance of current space experiments, protons and nuclei around the "knee" region ($\sim1\ PeV$) can only be observed by ground based experiments. Thanks to an innovative design, the High Energy cosmic-Radiation Detection (HERD) facility will a…
▽ More
The measurement of cosmic-ray individual spectra provides unique information regarding the origin and propagation of astro-particles. Due to the limited acceptance of current space experiments, protons and nuclei around the "knee" region ($\sim1\ PeV$) can only be observed by ground based experiments. Thanks to an innovative design, the High Energy cosmic-Radiation Detection (HERD) facility will allow direct observation up to this energy region: the instrument is mainly based on a 3D segmented, isotropic and homogeneous calorimeter which properly measures the energy of particles coming from each direction and it will be made of about 7500 LYSO cubic crystals. The read-out of the scintillation light is done with two independent systems: the first one based on wave-length shifting fibers coupled to Intensified scientific CMOS cameras, the second one is made of two photo-diodes with different active areas connected to a custom front-end electronics. This photo-diode system is designed to achieve a huge dynamic range, larger than $10^7$, while having a small power consumption, few mW per channel. Thanks to a good signal-to-noise ratio, the capability of a proper calibration, by using signals of both non-interacting and showering particles, is also guaranteed. In this paper, the current design and the performance obtained by several tests of the photo-diode read-out system are discussed.
△ Less
Submitted 8 August, 2022;
originally announced August 2022.
-
The CaloCube calorimeter for high-energy cosmic-ray measurements in space: performance of a large-scale prototype
Authors:
O. Adriani,
A. Agnesi,
S. Albergo,
M. Antonelli,
L. Auditore,
A. Basti,
E. Berti,
G. Bigongiari,
L. Bonechi,
M. Bongi,
V. Bonvicini,
S. Bottai,
P. Brogi,
G. Castellini,
P. W. Cattaneo,
C. Checchia,
R. D Alessandro,
S. Detti,
M. Fasoli,
N. Finetti,
A. Italiano,
P. Maestro,
P. S. Marrocchesi,
N. Mori,
G. Orzan
, et al. (23 additional authors not shown)
Abstract:
The direct observation of high-energy cosmic rays, up to the PeV energy region, will increasingly rely on highly performing calorimeters, and the physics performance will be primarily determined by their geometrical acceptance and energy resolution. Thus, it is extremely important to optimize their geometrical design, granularity and absorption depth, with respect to the totalmass of the apparatus…
▽ More
The direct observation of high-energy cosmic rays, up to the PeV energy region, will increasingly rely on highly performing calorimeters, and the physics performance will be primarily determined by their geometrical acceptance and energy resolution. Thus, it is extremely important to optimize their geometrical design, granularity and absorption depth, with respect to the totalmass of the apparatus, which is amongst the most important constraints for a space mission. CaloCube is an homogeneous calorimeter whose basic geometry is cubic and isotropic, obtained by filling the cubic volume with small cubic scintillating crystals. In this way it is possible to detect particles arriving from every direction in space, thus maximizing the acceptance. This design summarizes a three-year R&D activity, aiming to both optimize and study the full-scale performance of the calorimeter, in the perspective of a cosmic-ray space mission, and investigate a viable technical design by means of the construction of several sizable prototypes. A large scale prototype, made of a mesh of 5x5x18 CsI(Tl) crystals, has been constructed and tested on high-energy particle beams at CERN SPS accelerator. In this paper we describe the CaloCube design and present the results relative to the response of the large scale prototype to electrons.
△ Less
Submitted 4 October, 2021;
originally announced October 2021.
-
Tracker-In-Calorimeter (TIC): a calorimetric approach to tracking gamma rays in space experiments
Authors:
O. Adriani,
G. Ambrosi,
P. Azzarello,
A. Basti,
E. Berti,
B. Bertucci,
G. Bigongiari,
L. Bonechi,
M. Bongi,
S. Bottai,
M. Brianzi,
P. Brogi,
G. Castellini,
E. Catanzani,
C. Checchia,
R. D'Alessandro,
S. Detti,
M. Duranti,
N. Finetti,
V. Formato,
M. Ionica,
P. Maestro,
F. Maletta,
P. S. Marrocchesi,
N. Mori
, et al. (11 additional authors not shown)
Abstract:
A multi-messenger, space-based cosmic ray detector for gamma rays and charged particles poses several design challenges due to the different instrumental requirements for the two kind of particles. Gamma-ray detection requires layers of high Z materials for photon conversion and a tracking device with a long lever arm to achieve the necessary angular resolution to separate point sources; on the co…
▽ More
A multi-messenger, space-based cosmic ray detector for gamma rays and charged particles poses several design challenges due to the different instrumental requirements for the two kind of particles. Gamma-ray detection requires layers of high Z materials for photon conversion and a tracking device with a long lever arm to achieve the necessary angular resolution to separate point sources; on the contrary, charge measurements for atomic nuclei requires a thin detector in order to avoid unwanted fragmentation, and a shallow instrument so to maximize the geometric factor. In this paper, a novel tracking approach for gamma rays which tries to reconcile these two conflicting requirements is presented. The proposal is based on the Tracker-In-Calorimeter (TIC) design that relies on a highly-segmented calorimeter to track the incident gamma ray by sampling the lateral development of the electromagnetic shower at different depths. The effectiveness of this approach has been studied with Monte Carlo simulations and has been validated with test beam data of a detector prototype.
△ Less
Submitted 22 October, 2020; v1 submitted 4 August, 2020;
originally announced August 2020.
-
Forbush decreases and $<$ 2-day GCR flux non-recurrent variations studied with LISA Pathfinder
Authors:
C. Grimani,
M. Armano,
H. Audley,
J. Baird,
S. Benella,
P. Binetruy,
M. Born,
D. Bortoluzzi,
E. Castelli,
A. Cavalleri,
A. Cesarini,
A. M. Cruise,
K. Danzmann,
M. de Deus Silva,
I. Diepholz,
G. Dixon,
R. Dolesi,
M. Fabi,
L. Ferraioli,
V. Ferroni,
N. Finetti,
E. D. Fitzsimons,
M. Freschi,
L. Gesa,
F. Gibert
, et al. (60 additional authors not shown)
Abstract:
Non-recurrent short term variations of the galactic cosmic-ray (GCR) flux above 70 MeV n$^{-1}$ were observed between 2016 February 18 and 2017 July 3 aboard the European Space Agency LISA Pathfinder (LPF) mission orbiting around the Lagrange point L1 at 1.5$\times$10$^6$ km from Earth. The energy dependence of three Forbush decreases (FDs) is studied and reported here. A comparison of these obser…
▽ More
Non-recurrent short term variations of the galactic cosmic-ray (GCR) flux above 70 MeV n$^{-1}$ were observed between 2016 February 18 and 2017 July 3 aboard the European Space Agency LISA Pathfinder (LPF) mission orbiting around the Lagrange point L1 at 1.5$\times$10$^6$ km from Earth. The energy dependence of three Forbush decreases (FDs) is studied and reported here. A comparison of these observations with others carried out in space down to the energy of a few tens of MeV n$^{-1}$ shows that the same GCR flux parameterization applies to events of different intensity during the main phase. FD observations in L1 with LPF and geomagnetic storm occurrence is also presented. Finally, the characteristics of GCR flux non-recurrent variations (peaks and depressions) of duration $<$ 2 days and their association with interplanetary structures are investigated. It is found that, most likely, plasma compression regions between subsequent corotating high-speed streams cause peaks, while heliospheric current sheet crossing cause the majority of the depressions.
△ Less
Submitted 9 April, 2019;
originally announced April 2019.
-
Characteristics and energy dependence of recurrent galactic cosmic-ray flux depressions and of a Forbush decrease with LISA Pathfinder
Authors:
M. Armano,
H. Audley,
J. Baird,
M. Bassan,
S. Benella,
P. Binetruy,
M. Born,
D. Bortoluzzi,
A. Cavalleri,
A. Cesarini,
A. M. Cruise,
K. Danzmann,
M. de Deus Silva,
I. Diepholz,
G. Dixon,
R. Dolesi,
M. Fabi,
L. Ferraioli,
V. Ferroni,
N. Finetti,
E. D. Fitzsimons,
M. Freschi,
L. Gesa,
F. Gibert,
D. Giardini
, et al. (60 additional authors not shown)
Abstract:
Galactic cosmic-ray (GCR) energy spectra observed in the inner heliosphere are modulated by the solar activity, the solar polarity and structures of solar and interplanetary origin. A high counting rate particle detector (PD) aboard LISA Pathfinder (LPF), meant for subsystems diagnostics, was devoted to the measurement of galactic cosmic-ray and solar energetic particle integral fluxes above 70 Me…
▽ More
Galactic cosmic-ray (GCR) energy spectra observed in the inner heliosphere are modulated by the solar activity, the solar polarity and structures of solar and interplanetary origin. A high counting rate particle detector (PD) aboard LISA Pathfinder (LPF), meant for subsystems diagnostics, was devoted to the measurement of galactic cosmic-ray and solar energetic particle integral fluxes above 70 MeV n$^{-1}$ up to 6500 counts s$^{-1}$. PD data were gathered with a sampling time of 15 s. Characteristics and energy-dependence of GCR flux recurrent depressions and of a Forbush decrease dated August 2, 2016 are reported here. The capability of interplanetary missions, carrying PDs for instrument performance purposes, in monitoring the passage of interplanetary coronal mass ejections (ICMEs) is also discussed.
△ Less
Submitted 27 April, 2018; v1 submitted 23 February, 2018;
originally announced February 2018.
-
CaloCube: a novel calorimeter for high-energy cosmic rays in space
Authors:
P. W. Cattaneo,
O. Adriani,
S. Albergo,
L. Auditore,
A. Basti,
E. Berti,
G. Bigongiari,
L. Bonechi,
S. Bonechi,
M. Bongi,
V. Bonvicini,
S. Bottai,
P. Brogi,
G. Carotenuto,
G. Castellini,
R. ďAlessandro,
S. Detti,
M. Fasoli,
N. Finetti,
A. Italiano,
P. Lenzi,
P. Maestro,
P. S. Marrocchesi,
N. Mori,
M. Olmi
, et al. (21 additional authors not shown)
Abstract:
In order to extend the direct observation of high-energy cosmic rays up to the PeV region, highly performing calorimeters with large geometrical acceptance and high energy resolution are required. Within the constraint of the total mass of the apparatus, crucial for a space mission, the calorimeters must be optimized with respect to their geometrical acceptance, granularity and absorption depth. C…
▽ More
In order to extend the direct observation of high-energy cosmic rays up to the PeV region, highly performing calorimeters with large geometrical acceptance and high energy resolution are required. Within the constraint of the total mass of the apparatus, crucial for a space mission, the calorimeters must be optimized with respect to their geometrical acceptance, granularity and absorption depth. CaloCube is a homogeneous calorimeter with cubic geometry, to maximise the acceptance being sensitive to particles from every direction in space; granularity is obtained by relying on small cubic scintillating crystals as active elements. Different scintillating materials have been studied. The crystal sizes and spacing among them have been optimized with respect to the energy resolution. A prototype, based on CsI(Tl) cubic crystals, has been constructed and tested with particle beams. Some results of tests with different beams at CERN are presented.
△ Less
Submitted 23 May, 2017; v1 submitted 19 May, 2017;
originally announced May 2017.
