-
Active deployable primary mirrors on CubeSat
Authors:
Noah Schwartz,
Maria Milanova,
William Brzozowski,
Stephen Todd,
Zeshan Ali,
Lucie Buron,
Jean-François-Sauvage,
Charlotte Bond,
Heather Bruce,
Phil Rees,
Marc Ferrari,
Donald MacLeod
Abstract:
The volume available on small satellites restricts the size of optical apertures to a few centimetres, limiting the Ground-Sampling Distance (GSD) in the visible to typically 3 m at 500 km. We present in this paper the latest development of a laboratory demonstrator of a segmented deployable telescope that will triple the achievable ground resolution and improve photometric capability of CubeSat i…
▽ More
The volume available on small satellites restricts the size of optical apertures to a few centimetres, limiting the Ground-Sampling Distance (GSD) in the visible to typically 3 m at 500 km. We present in this paper the latest development of a laboratory demonstrator of a segmented deployable telescope that will triple the achievable ground resolution and improve photometric capability of CubeSat imagers. Each mirror segment is folded for launch and unfolds in space. We demonstrate through laboratory validation very high deployment repeatability of the mirrors <{\pm}5 μm. To enable diffraction-limited imaging, segments are controlled in piston, tip, and tilt. This is achieved by an initial coarse alignment of the mirrors followed by a fine phasing step. Finally, we investigate the impact of the thermal environment on high-order wavefront error and the conceptual design of a deployable secondary fitting inside 1U.
△ Less
Submitted 26 May, 2021;
originally announced May 2021.
-
Analytical calculation of Hermite-Gauss and Laguerre-Gauss modes on a bullseye photodiode
Authors:
Charlotte Bond,
Paul Fulda,
Andreas Freise
Abstract:
This note describes the analytical derivation of the response of bullseye detectors to optical beats between higher-order spatial modes of the Laguerre-Gauss form, and subsequently the Hermite-Gauss form. Also included is a comparison with numerically calculated beat coefficients, and a simple example of the use of the resulting beat coefficients in simulating a mode mismatch sensor for a Fabry-Pe…
▽ More
This note describes the analytical derivation of the response of bullseye detectors to optical beats between higher-order spatial modes of the Laguerre-Gauss form, and subsequently the Hermite-Gauss form. Also included is a comparison with numerically calculated beat coefficients, and a simple example of the use of the resulting beat coefficients in simulating a mode mismatch sensor for a Fabry-Perot cavity.
△ Less
Submitted 3 June, 2016;
originally announced June 2016.
-
The Sensitivity of the Advanced LIGO Detectors at the Beginning of Gravitational Wave Astronomy
Authors:
D. V. Martynov,
E. D. Hall,
B. P. Abbott,
R. Abbott,
T. D. Abbott,
C. Adams,
R. X. Adhikari,
R. A. Anderson,
S. B. Anderson,
K. Arai,
M. A. Arain,
S. M. Aston,
L. Austin,
S. W. Ballmer,
M. Barbet,
D. Barker,
B. Barr,
L. Barsotti,
J. Bartlett,
M. A. Barton,
I. Bartos,
J. C. Batch,
A. S. Bell,
I. Belopolski,
J. Bergman
, et al. (239 additional authors not shown)
Abstract:
The Laser Interferometer Gravitational Wave Observatory (LIGO) consists of two widely separated 4 km laser interferometers designed to detect gravitational waves from distant astrophysical sources in the frequency range from 10 Hz to 10 kHz. The first observation run of the Advanced LIGO detectors started in September 2015 and ended in January 2016. A strain sensitivity of better than…
▽ More
The Laser Interferometer Gravitational Wave Observatory (LIGO) consists of two widely separated 4 km laser interferometers designed to detect gravitational waves from distant astrophysical sources in the frequency range from 10 Hz to 10 kHz. The first observation run of the Advanced LIGO detectors started in September 2015 and ended in January 2016. A strain sensitivity of better than $10^{-23}/\sqrt{\text{Hz}}$ was achieved around 100 Hz. Understanding both the fundamental and the technical noise sources was critical for increasing the observable volume in the universe. The average distance at which coalescing binary black hole systems with individual masses of 30 $M_\odot$ could be detected was 1.3 Gpc. Similarly, the range for binary neutron star inspirals was about 75 Mpc. With respect to the initial detectors, the observable volume of Universe increased respectively by a factor 69 and 43. These improvements allowed Advanced LIGO to detect the gravitational wave signal from the binary black hole coalescence, known as GW150914.
△ Less
Submitted 10 February, 2018; v1 submitted 1 April, 2016;
originally announced April 2016.
-
Calibration of the Advanced LIGO detectors for the discovery of the binary black-hole merger GW150914
Authors:
The LIGO Scientific Collaboration,
B. P. Abbott,
R. Abbott,
T. D. Abbott,
M. R. Abernathy,
K. Ackley,
C. Adams,
P. Addesso,
R. X. Adhikari,
V. B. Adya,
C. Affeldt,
N. Aggarwal,
O. D. Aguiar,
A. Ain,
P. Ajith,
B. Allen,
P. A. Altin,
D. V. Amariutei,
S. B. Anderson,
W. G. Anderson,
K. Arai,
M. C. Araya,
C. C. Arceneaux,
J. S. Areeda,
K. G. Arun
, et al. (702 additional authors not shown)
Abstract:
In Advanced LIGO, detection and astrophysical source parameter estimation of the binary black hole merger GW150914 requires a calibrated estimate of the gravitational-wave strain sensed by the detectors. Producing an estimate from each detector's differential arm length control loop readout signals requires applying time domain filters, which are designed from a frequency domain model of the detec…
▽ More
In Advanced LIGO, detection and astrophysical source parameter estimation of the binary black hole merger GW150914 requires a calibrated estimate of the gravitational-wave strain sensed by the detectors. Producing an estimate from each detector's differential arm length control loop readout signals requires applying time domain filters, which are designed from a frequency domain model of the detector's gravitational-wave response. The gravitational-wave response model is determined by the detector's opto-mechanical response and the properties of its feedback control system. The measurements used to validate the model and characterize its uncertainty are derived primarily from a dedicated photon radiation pressure actuator, with cross-checks provided by optical and radio frequency references. We describe how the gravitational-wave readout signal is calibrated into equivalent gravitational-wave-induced strain and how the statistical uncertainties and systematic errors are assessed. Detector data collected over 38 calendar days, from September 12 to October 20, 2015, contain the event GW150914 and approximately 16 of coincident data used to estimate the event false alarm probability. The calibration uncertainty is less than 10% in magnitude and 10 degrees in phase across the relevant frequency band 20 Hz to 1 kHz.
△ Less
Submitted 28 February, 2017; v1 submitted 11 February, 2016;
originally announced February 2016.
-
Design study of the KAGRA output mode-cleaner
Authors:
Ayaka Kumeta,
Charlotte Bond,
Kentaro Somiya
Abstract:
Most second-generation gravitational-wave detectors employ an optical resonator called an output mode-cleaner (OMC), which filters out junk light from the signal and the reference light, before it reaches the detection photodiode located at the asymmetric port of the large-scale interferometer. The optical parameters of the OMC should be carefully chosen to satisfy the requirements to filter out u…
▽ More
Most second-generation gravitational-wave detectors employ an optical resonator called an output mode-cleaner (OMC), which filters out junk light from the signal and the reference light, before it reaches the detection photodiode located at the asymmetric port of the large-scale interferometer. The optical parameters of the OMC should be carefully chosen to satisfy the requirements to filter out unwanted light whilst transmitting the gravitational wave signal and reference light. The Japanese gravitational-wave detector KAGRA plans to use a very small amount of reference light to minimize the influence of quantum noise for gravitational waves from binary neutron stars, and hence the requirements to the OMC are more challenging than for other advanced detectors. In this paper, we present the result of numerical simulations, which verify that the OMC requirements are satisfied with the current design. We use the simulation program FINESSE and realistic mirror phase maps that have the same surface quality as the KAGRA test masses.
△ Less
Submitted 22 July, 2014;
originally announced July 2014.
-
Interferometer responses to gravitational waves: Comparing FINESSE simulations and analytical solutions
Authors:
Charlotte Bond,
Daniel Brown,
Andreas Freise
Abstract:
A comparison of analytic calculations and FINESSE simulations of interferometer responses to gravitational wave strain. The response to a gravitational wave is gradually built up from the effect of modulating a space by a gravitational wave to Sagnac and Michelson interferometers with and without arm cavities. This document details the steps necessary to perform such simulations in FINESSE and exp…
▽ More
A comparison of analytic calculations and FINESSE simulations of interferometer responses to gravitational wave strain. The response to a gravitational wave is gradually built up from the effect of modulating a space by a gravitational wave to Sagnac and Michelson interferometers with and without arm cavities. This document details the steps necessary to perform such simulations in FINESSE and explicitly derives the interferometer response equations.
△ Less
Submitted 28 June, 2013;
originally announced June 2013.
-
Finesse, Frequency domain INterferomEter Simulation SoftwarE
Authors:
Andreas Freise,
Daniel Brown,
Charlotte Bond
Abstract:
Finesse is a fast interferometer simulation program. For a given optical setup, it computes the light field amplitudes at every point in the interferometer assuming a steady state. To do so, the interferometer description is translated into a set of linear equations that are solved numerically. For convenience, a number of standard analyses can be performed automatically by the program, namely com…
▽ More
Finesse is a fast interferometer simulation program. For a given optical setup, it computes the light field amplitudes at every point in the interferometer assuming a steady state. To do so, the interferometer description is translated into a set of linear equations that are solved numerically. For convenience, a number of standard analyses can be performed automatically by the program, namely computing modulation-demodulation error signals, transfer functions, shot-noise-limited sensitivities, and beam shapes. Finesse can perform the analysis using the plane-wave approximation or Hermite-Gauss modes. The latter allows computation of the properties of optical systems like telescopes and the effects of mode matching and mirror angular positions.
△ Less
Submitted 12 June, 2013;
originally announced June 2013.
-
Realistic polarizing Sagnac topology with DC readout for the Einstein Telescope
Authors:
Mengyao Wang,
Charlotte Bond,
Daniel Brown,
Frank Brueckner,
Ludovico Carbone,
Rebecca Palmer,
Andreas Freise
Abstract:
The Einstein Telescope (ET) is a proposed future gravitational wave detector. Its design is original, using a triangular orientation of three detectors and a xylophone configuration, splitting each detector into one high-frequency and one low-frequency system. In other aspects the current design retains the dual-recycled Michelson interferometer typical of current detectors, such as Advanced LIGO.…
▽ More
The Einstein Telescope (ET) is a proposed future gravitational wave detector. Its design is original, using a triangular orientation of three detectors and a xylophone configuration, splitting each detector into one high-frequency and one low-frequency system. In other aspects the current design retains the dual-recycled Michelson interferometer typical of current detectors, such as Advanced LIGO. In this paper, we investigate the feasibility of replacing the low-frequency part of the ET detectors with a Sagnac interferometer. We show that a Sagnac interferometer, using realistic optical parameters based on the ET design, could provide a similar level of radiation pressure noise suppression without the need for a signal recycling mirror and the extensive filter cavities. We consider the practical issues of a realistic, power-recycled Sagnac, using linear arm cavities and polarizing optics. In particular, we investigate the effects of nonperfect polarizing optics and propose a new method for the generation of a local oscillator field similar to the DC readout scheme of current detectors.
△ Less
Submitted 2 April, 2014; v1 submitted 21 March, 2013;
originally announced March 2013.
-
Computer-games for gravitational wave science outreach: Black Hole Pong and Space Time Quest
Authors:
L. Carbone,
C. Bond,
D. Brown,
F. Brueckner,
K. Grover,
D. Lodhia,
C. M. F. Mingarelli,
P. Fulda,
R. J. E. Smith,
R. Unwin,
A. Vecchio,
M. Wang,
L. Whalley,
A. Freise
Abstract:
We have established a program aimed to the development of small computer applications and web applets to be used for educational purposes and to teach gravitational waves physics and technology, and for the general gravitational wave outreach activities. The computer programs are generated in collaboration with undergraduates and summer students as part of our teaching activities, and are freely d…
▽ More
We have established a program aimed to the development of small computer applications and web applets to be used for educational purposes and to teach gravitational waves physics and technology, and for the general gravitational wave outreach activities. The computer programs are generated in collaboration with undergraduates and summer students as part of our teaching activities, and are freely distributed on a dedicated website. As part of this program, we have developed two computer-games related to gravitational wave science: 'Black Hole Pong' and 'Space Time Quest'. In this article we overview our computer related outreach activity, present and discuss the games and their educational aspects, and report on some positive feedback received.
△ Less
Submitted 13 March, 2012; v1 submitted 16 November, 2011;
originally announced November 2011.
