-
Towards a Low-SWaP 1024-beam Digital Array: A 32-beam Sub-system at 5.8 GHz
Authors:
Arjuna Madanayake,
Viduneth Ariyarathna,
Suresh Madishetty,
Sravan Pulipati,
R. J. Cintra,
Diego Coelho,
Raíza Oliveira,
Fábio M. Bayer,
Leonid Belostotski,
Soumyajit Mandal,
Theodore S. Rappaport
Abstract:
Millimeter wave communications require multibeam beamforming in order to utilize wireless channels that suffer from obstructions, path loss, and multi-path effects. Digital multibeam beamforming has maximum degrees of freedom compared to analog phased arrays. However, circuit complexity and power consumption are important constraints for digital multibeam systems. A low-complexity digital computin…
▽ More
Millimeter wave communications require multibeam beamforming in order to utilize wireless channels that suffer from obstructions, path loss, and multi-path effects. Digital multibeam beamforming has maximum degrees of freedom compared to analog phased arrays. However, circuit complexity and power consumption are important constraints for digital multibeam systems. A low-complexity digital computing architecture is proposed for a multiplication-free 32-point linear transform that approximates multiple simultaneous RF beams similar to a discrete Fourier transform (DFT). Arithmetic complexity due to multiplication is reduced from the FFT complexity of $\mathcal{O}(N\: \log N)$ for DFT realizations, down to zero, thus yielding a 46% and 55% reduction in chip area and dynamic power consumption, respectively, for the $N=32$ case considered. The paper describes the proposed 32-point DFT approximation targeting a 1024-beams using a 2D array, and shows the multiplierless approximation and its map** to a 32-beam sub-system consisting of 5.8 GHz antennas that can be used for generating 1024 digital beams without multiplications. Real-time beam computation is achieved using a Xilinx FPGA at 120 MHz bandwidth per beam. Theoretical beam performance is compared with measured RF patterns from both a fixed-point FFT as well as the proposed multiplier-free algorithm and are in good agreement.
△ Less
Submitted 29 May, 2024; v1 submitted 18 July, 2022;
originally announced July 2022.
-
Millimeter-Wave Antenna Array Diagnosis with Partial Channel State Information
Authors:
George Medina,
Akashdeep Singh Jida,
Sravan Pulipati,
Rohith Talwar,
Nancy Amala J,
Tareq Y. Al-Naffouri,
Arjuna Madanayake,
Mohammed Eltayeb
Abstract:
Large antenna arrays enable directional precoding for Millimeter-Wave (mmWave) systems and provide sufficient link budget to combat the high path-loss at these frequencies. Due to atmospheric conditions and hardware malfunction, outdoor mmWave antenna arrays are prone to blockages or complete failures. This results in a modified array geometry, distorted far-field radiation pattern, and system per…
▽ More
Large antenna arrays enable directional precoding for Millimeter-Wave (mmWave) systems and provide sufficient link budget to combat the high path-loss at these frequencies. Due to atmospheric conditions and hardware malfunction, outdoor mmWave antenna arrays are prone to blockages or complete failures. This results in a modified array geometry, distorted far-field radiation pattern, and system performance degradation. Recent remote array diagnostic techniques have emerged as an effective way to detect defective antenna elements in an array with few diagnostic measurements. These techniques, however, require full and perfect channel state information (CSI), which can be challenging to acquire in the presence of antenna faults. This paper proposes a new remote array diagnosis technique that relaxes the need for full CSI and only requires knowledge of the incident angle-of-arrivals, i.e. partial channel knowledge. Numerical results demonstrate the effectiveness of the proposed technique and show that fault detection can be obtained with comparable number of diagnostic measurements required by diagnostic techniques based on full channel knowledge. In presence of channel estimation errors, the proposed technique is shown to out-perform recently proposed array diagnostic techniques.
△ Less
Submitted 2 November, 2020;
originally announced November 2020.
-
Xilinx RF-SoC-based Digital Multi-Beam Array Processors for 28/60~GHz Wireless Testbeds
Authors:
Sravan Pulipati,
Viduneth Ariyarathna,
Aditya Dhananjay,
Mohammed E. Eltayeb,
Marco Mezzavilla,
Josep M. Jornet,
Soumyajit Mandal,
Shubhendu Bhardwaj,
Arjuna Madanayake
Abstract:
Emerging wireless applications such as 5G cellular, large intelligent surfaces (LIS), and holographic massive MIMO require antenna array processing at mm-wave frequencies with large numbers of independent digital transceivers. This paper summarizes the authors' recent progress on the design and testing of 28 GHz and 60 GHz fully-digital array processing platforms based on wideband reconfigurable F…
▽ More
Emerging wireless applications such as 5G cellular, large intelligent surfaces (LIS), and holographic massive MIMO require antenna array processing at mm-wave frequencies with large numbers of independent digital transceivers. This paper summarizes the authors' recent progress on the design and testing of 28 GHz and 60 GHz fully-digital array processing platforms based on wideband reconfigurable FPGA-based software-defined radios (SDRs). The digital baseband and microwave interfacing aspects of the SDRs are implemented on single-chip RF system-on-chip (RF-SoC) processors from Xilinx. Two versions of the RF-SoC technology (ZCU-111 and ZCU-1275) were used to implement fully-digital real-time array processors at 28~GHz (realizing 4 parallel beams with 0.8 GHz bandwidth per beam) and 60~GHz (realizing 4 parallel beams with 1.8~GHz bandwidth per beam). Dielectric lenslet arrays fed by a digital phased-array feed (PAF) located on the focal plane are proposed for further increasing antenna array gain.
△ Less
Submitted 3 August, 2020;
originally announced August 2020.
-
A Passive STAR Microwave Circuit for 1-3 GHz Self-Interference Cancellation
Authors:
Udara De Silva,
Sravan Pulipati,
Satheesh Bojja Venkatakrishnan,
Shubhendu Bhardwaj,
Arjuna Madanayake
Abstract:
Simultaneous transmit and receive (STAR) allows full-duplex operation of a radio, which leads to doubled capacity for a given bandwidth. A circulator with high-isolation between transmit and receive ports, and low-loss from the antenna to receive port is typically required for achieving STAR. Conventional circulators do not offer wideband performance. Although wideband circulators have been propos…
▽ More
Simultaneous transmit and receive (STAR) allows full-duplex operation of a radio, which leads to doubled capacity for a given bandwidth. A circulator with high-isolation between transmit and receive ports, and low-loss from the antenna to receive port is typically required for achieving STAR. Conventional circulators do not offer wideband performance. Although wideband circulators have been proposed using parametric, switched delay-line/capacitor, and N-path filter techniques using custom integrated circuits, these magnet-free devices have non-linearity, noise, aliasing, and switching noise injection issues. In this paper, a STAR front-end based on passive linear microwave circuit is proposed. Here, a dummy antenna located inside a miniature RF-silent absorption chamber allows circulator-free STAR using simple COTS components. The proposed approach is highly-linear, free from noise, does not require switching or parametric modulation circuits, and has virtually unlimited bandwidth only set by the performance of COTS passive microwave components. The trade-off is relatively large size of the miniature RF-shielded chamber, making this suitable for base-station side applications. Preliminary results show the measured performance of Tx/Rx isolation between 25-60 dB in the 1.0-3.0 GHz range, and 50-60 dB for the 2.4-2.7 GHz range.
△ Less
Submitted 17 August, 2020; v1 submitted 3 August, 2020;
originally announced August 2020.
-
A Direct- Conversion Digital Beamforming Array Receiver with 800 MHz Channel Bandwidth at 28 GHz using Xilinx RF SoC
Authors:
Sravan Pulipati,
Viduneth Ariyarathna,
Udara De Silva,
Najath Akram,
Elias Alwan,
Arjuna Madanayake,
Soumyajit Mandal,
Theodore S. Rappaport
Abstract:
This paper discusses early results associated with a fully-digital direct-conversion array receiver at 28~GHz. The proposed receiver makes use of commercial off-the-shelf (COTS) electronics, including the receiver chain. The design consists of a custom 28~GHz patch antenna sub-array providing gain in the elevation plane, with azimuthal plane beamforming provided by real-time digital signal process…
▽ More
This paper discusses early results associated with a fully-digital direct-conversion array receiver at 28~GHz. The proposed receiver makes use of commercial off-the-shelf (COTS) electronics, including the receiver chain. The design consists of a custom 28~GHz patch antenna sub-array providing gain in the elevation plane, with azimuthal plane beamforming provided by real-time digital signal processing (DSP) algorithms running on a ** platform.
△ Less
Submitted 20 November, 2019;
originally announced November 2019.
