-
Numerical determination of iron dust laminar flame speeds with the counterflow twin-flame technique
Authors:
C. E. A. G. van Gool,
T. Hazenberg,
J. A. van Oijen,
L. P. H. de Goey
Abstract:
Iron dust counter-flow flames have been studied with the low-Mach-number combustion approximation. The model considers full coupling between the two phases, including particle/droplet drag. The dispersed phase flow strain relations are derived under the assumption of low Reynolds number conditions. The importance of solving a particle flow strain model is demonstrated by comparing three different…
▽ More
Iron dust counter-flow flames have been studied with the low-Mach-number combustion approximation. The model considers full coupling between the two phases, including particle/droplet drag. The dispersed phase flow strain relations are derived under the assumption of low Reynolds number conditions. The importance of solving a particle flow strain model is demonstrated by comparing three different models: a free unstrained flame, a counter-flow flame where particle flow strain is assumed equal to gas flow strain and one case in which the particle flow strain is solved. All three cases showed preferential diffusion effects, due to the lack of diffusion of iron in the fuel mixture, e.g. DFe,m = 0. The preferential diffusion effect causes a peak in the fuel equivalence ratio in the preheat zone. At the burned side, the combined effect of strain and preferential diffusion showed a decrease in fuel equivalence ratio. Inertia effects, which are only included in the resolved particle flow strain case, counteract this effect and result in an increase of the fuel equivalence ratio at the burned side. A laminar flame speed analysis is performed and a recommendation is given on how to experimentally determine the flame speed in a counter-flow set-up.
△ Less
Submitted 8 December, 2023;
originally announced December 2023.
-
On the surface chemisorption of oxidizing fine iron particles: insights gained from molecular dynamics simulations
Authors:
L. C Thijs,
E. Kritikos,
A. Giusti,
W. J. S Ramaekers,
J. A. van Oijen,
L. P. H de Goey,
X. C. Mi
Abstract:
Molecular dynamics (MD) simulations are performed to investigate the thermal and mass accommodation coefficients (TAC and MAC, respectively) for the combination of iron(-oxide) and air. The obtained values of TAC and MAC are then used in a point-particle Knudsen model to investigate the effect of chemisorption and the Knudsen transition regime on the combustion behavior of (fine) iron particles. T…
▽ More
Molecular dynamics (MD) simulations are performed to investigate the thermal and mass accommodation coefficients (TAC and MAC, respectively) for the combination of iron(-oxide) and air. The obtained values of TAC and MAC are then used in a point-particle Knudsen model to investigate the effect of chemisorption and the Knudsen transition regime on the combustion behavior of (fine) iron particles. The thermal accommodation for the interactions of $\mathrm{Fe}$ with $\mathrm{N_2}$ and $\mathrm{Fe_xO_y}$ with $\mathrm{O_2}$ is investigated for different surface temperatures, while the mass accommodation coefficient for iron(-oxide) with oxygen is investigated for different initial oxidation stages $Z_\mathrm{O}$, which represents the molar ratio of $\mathrm{O}/\left(\mathrm{O} + \mathrm{Fe}\right)$, and different surface temperatures. The MAC decreases fast from unity to 0.03 as $Z_\mathrm{O}$ increases from 0 to 0.5 and then diminishes as $Z_\mathrm{O}$ further increases to 0.57. By incorporating the MD-informed accommodation coefficients into the single iron particle combustion model,a new temperature evolution for single iron particles is observed compared to results obtained with previously developed continuum models. Specifically, results of the present simulations show that the oxidation process continues after the particle reaching the peak temperature, while previous models predicting that the maximum temperature was attained when the particle is oxidized to $Z_\mathrm{O} = 0.5$. Since the rate of oxidation slows down as the MAC decreases with an increasing oxidation stage, the rate of heat loss exceeds the rate of heat release upon reaching the maximum temperature, while the particle is not yet oxidized to $Z_\mathrm{O} = 0.5$. Finally, the effect of transition-regime heat and mass transfer on the combustion behavior of fine iron particles is investigated and discussed.
△ Less
Submitted 19 April, 2023; v1 submitted 13 December, 2022;
originally announced December 2022.
-
Characteristics of a novel nanosecond DBD microplasma reactor for flow applications
Authors:
A. Elkholy,
E. van Veldhuizen,
S. Nijdam,
U. Ebert,
J. van Oijen,
N. Dam,
L. Philip H. de Goey
Abstract:
We present a novel microplasma flow reactor using a dielectric barrier discharge (DBD) driven by repetitively nanosecond high-voltage pulses. Our DBD-based geometry can generate a non-thermal plasma discharge at atmospheric pressure and below in a regular pattern of micro-channels. This reactor can work continuously up to about 100 minutes in air, depending on pulse repetition rate and operating p…
▽ More
We present a novel microplasma flow reactor using a dielectric barrier discharge (DBD) driven by repetitively nanosecond high-voltage pulses. Our DBD-based geometry can generate a non-thermal plasma discharge at atmospheric pressure and below in a regular pattern of micro-channels. This reactor can work continuously up to about 100 minutes in air, depending on pulse repetition rate and operating pressure. We here present the geometry and the main characteristics of the reactor. Pulse energies of 1.9 $μ$J and 2.7 $μ$J per channel at atmospheric pressure and 50 mbar, respectively, have been determined by time-resolved measurements of current and voltage. Time-resolved optical emission spectroscopy measurements have been performed to calculate the relative species concentrations and temperatures (vibrational and rotational) of the discharge. Effects of the operating pressure and the flow velocity on the discharge intensity have been investigated. In addition, the effective reduced electric field strength E/N has been obtained from the intensity ratio of vibronic emission bands of molecular nitrogen at different operating pressures. The derived effective E/N increases gradually from 500 Td to 600 Td when decreasing the pressure from one bar to 0.4 bar. Below 0.4 bar, further pressure reduction results in a significant increase in the effective E/N up to about 2000 Td at 50 mbar.
△ Less
Submitted 8 September, 2017;
originally announced September 2017.
