-
Enhanced Frequency noise suppression for LISA by combining cavity and arm locking control systems
Authors:
Jobin Thomas Valliyakalayil,
Andrew J. H. Sutton,
Robert E. Spero,
Daniel A. Shaddock,
Kirk McKenzie
Abstract:
This paper presents a novel method for laser frequency stabilisation in the Laser Interferometer Space Antenna (LISA) mission by locking a laser to two stable length references - the arms of the interferometer and an on-board optical cavity. The two references are digitally fused using carefully designed control systems, attempting minimal or no changes to the baseline LISA mission hardware. The i…
▽ More
This paper presents a novel method for laser frequency stabilisation in the Laser Interferometer Space Antenna (LISA) mission by locking a laser to two stable length references - the arms of the interferometer and an on-board optical cavity. The two references are digitally fused using carefully designed control systems, attempting minimal or no changes to the baseline LISA mission hardware. The interferometer arm(s) provides the most stable reference available in the LISA science band (0.1 mHz - 1 Hz), while the cavity sensor's wide-band and linear readout enables additional control system gain below and above the LISA band. The main technical issue with this dual sensor approach is the undesirable slow laser frequency pulling which couples into the control system with the imperfect knowledge of the Doppler shift of the light due to relative spacecraft motion along the LISA arm. This paper outlines requirements on the Doppler shift knowledge to maintain the cavity well within the resonance when activating the fused control system. Two Doppler shift estimation methods are presented that use the already on-board measurements, the inter-spacecraft interferometer link (the main science measurement), and the absolute inter-spacecraft laser ranging system. Both methods reach the required precision after a few thousand seconds of measurement integration. The paper demonstrates an approach to initialise and engage the proposed laser stabilization system, starting from free-running laser and ending with the dual sensor frequency control system. The results show that the technique lowers the residual laser frequency noise in the LISA science band by over 3 orders of magnitude, potentially allowing the requirements on Time-Delay-Interferometry (TDI) to be relaxed - possibly to the point where first-generation TDI may be sufficient.
△ Less
Submitted 1 March, 2022; v1 submitted 20 October, 2021;
originally announced October 2021.
-
Analysis of GRACE Follow-On Laser Ranging Interferometer derived inter-satellite pointing angles
Authors:
Sujata Goswami,
Samuel P. Francis,
Tamara Bandikova,
Robert E Spero
Abstract:
Gravity Recovery and Climate Experiment Follow-On (GRACE-FO) was launched on May 22, 2018. It carries the Laser Ranging Interferometer (LRI) as a technology demonstrator that measures the inter-satellite range with nanometer precision using a laser-link between satellites. To maintain the laser-link between satellites, the LRI uses the beam steering method: a Fast Steering Mirror (FSM) is actuated…
▽ More
Gravity Recovery and Climate Experiment Follow-On (GRACE-FO) was launched on May 22, 2018. It carries the Laser Ranging Interferometer (LRI) as a technology demonstrator that measures the inter-satellite range with nanometer precision using a laser-link between satellites. To maintain the laser-link between satellites, the LRI uses the beam steering method: a Fast Steering Mirror (FSM) is actuated to correct for misalignment between the incoming and outgoing laser beams. From the FSM commands, we can compute the inter-satellite pitch and yaw angles. These angles provide information about the spacecraft's relative orientation with respect to line-of-sight (LOS). We analyze LRI derived inter-satellite pointing angles for 2019 and 2020. Further, we present its comparison with the pointing angles derived from GRACE-FO SCA1B data, which represents the spacecraft attitude computed from star cameras and Inertial Measurement Unit (IMU) data using a Kalman filter. We discuss the correlations seen between the laser based attitude data and the spacecraft temperature variations. This analysis serves as the basis to explore the potential of this new attitude product obtained from the Differential Wavefront Sensing (DWS) control of a FSM.
△ Less
Submitted 5 July, 2021;
originally announced July 2021.
-
Experimental Demonstration of Time-Delay Interferometry for the Laser Interferometer Space Antenna
Authors:
Glenn de Vine,
Brent Ware,
Kirk McKenzie,
Robert E. Spero,
William M. Klipstein,
Daniel A. Shaddock
Abstract:
We report on the first demonstration of time-delay interferometry (TDI) for LISA, the Laser Interferometer Space Antenna. TDI was implemented in a laboratory experiment designed to mimic the noise couplings that will occur in LISA. TDI suppressed laser frequency noise by approximately 10^9 and clock phase noise by 6x10^4, recovering the intrinsic displacement noise floor of our laboratory test bed…
▽ More
We report on the first demonstration of time-delay interferometry (TDI) for LISA, the Laser Interferometer Space Antenna. TDI was implemented in a laboratory experiment designed to mimic the noise couplings that will occur in LISA. TDI suppressed laser frequency noise by approximately 10^9 and clock phase noise by 6x10^4, recovering the intrinsic displacement noise floor of our laboratory test bed. This removal of laser frequency noise and clock phase noise in post-processing marks the first experimental validation of the LISA measurement scheme.
△ Less
Submitted 12 May, 2010;
originally announced May 2010.
-
The performance of arm locking in LISA
Authors:
Kirk McKenzie,
Robert E. Spero,
Daniel A. Shaddock
Abstract:
For the laser interferometer space antenna (LISA) to reach it's design sensitivity, the coupling of the free running laser frequency noise to the signal readout must be reduced by more than 14 orders of magnitude. One technique employed to reduce the laser frequency noise will be arm locking, where the laser frequency is locked to the LISA arm length. This paper details an implementation of arm…
▽ More
For the laser interferometer space antenna (LISA) to reach it's design sensitivity, the coupling of the free running laser frequency noise to the signal readout must be reduced by more than 14 orders of magnitude. One technique employed to reduce the laser frequency noise will be arm locking, where the laser frequency is locked to the LISA arm length. This paper details an implementation of arm locking, studies orbital effects, the impact of errors in the Doppler knowledge, and noise limits. The noise performance of arm locking is calculated with the inclusion of the dominant expected noise sources: ultra stable oscillator (clock) noise, spacecraft motion, and shot noise. Studying these issues reveals that although dual arm locking [A. Sutton & D. A Shaddock, Phys. Rev. D 78, 082001 (2008).] has advantages over single (or common) arm locking in terms of allowing high gain, it has disadvantages in both laser frequency pulling and noise performance. We address this by proposing a hybrid sensor, retaining the benefits of common and dual arm locking sensors. We present a detailed design of an arm locking controller and perform an analysis of the expected performance when used with and without laser pre-stabilization. We observe that the sensor phase changes beneficially near unity-gain frequencies of the arm-locking controller, allowing a factor of 10 more gain than previously believed, without degrading stability. We show that the LISA frequency noise goal can be realized with arm locking and Time-Delay Interferometry only, without any form of pre-stabilization.
△ Less
Submitted 4 August, 2009; v1 submitted 3 August, 2009;
originally announced August 2009.
-
Post-processed time-delay interferometry for LISA
Authors:
D. A. Shaddock,
B. Ware,
R. E. Spero,
M. Vallisneri
Abstract:
High-precision interpolation of LISA phase measurements allows signal reconstruction and formulation of Time-Delay Interferometry (TDI) combinations to be conducted in post-processing. The reconstruction is based on phase measurements made at approximately 10 Hz, at regular intervals independent of the TDI delay times. Interpolation introduces an error less than 1e-8 with continuous data segment…
▽ More
High-precision interpolation of LISA phase measurements allows signal reconstruction and formulation of Time-Delay Interferometry (TDI) combinations to be conducted in post-processing. The reconstruction is based on phase measurements made at approximately 10 Hz, at regular intervals independent of the TDI delay times. Interpolation introduces an error less than 1e-8 with continuous data segments as short as two seconds in duration. Potential simplifications in the design and operation of LISA are presented.
△ Less
Submitted 25 June, 2004;
originally announced June 2004.
