Effect of the crystallographic c-axis orientation on the tribological properties of the few-layer PtSe2
Authors:
Andrii Kozak,
Michaela Sojkova,
Filip Gucmann,
Michal Bodik,
Karol Vegso,
Edmund Dobrocka,
Igor Pis,
Federica Bondino,
Martin Hulman,
Peter Siffalovic,
Milan Tapajna
Abstract:
Two-dimensional (2D) transition metal dichalcogenides are potential candidates for ultrathin solid-state lubricants in low-dimensional systems owing to their flatness, high in-plane mechanical strength, and low shear interlayer strength. Yet, the effects of surface topography and surface chemistry on the tribological properties of 2D layers are still unclear. In this work, we performed a comparati…
▽ More
Two-dimensional (2D) transition metal dichalcogenides are potential candidates for ultrathin solid-state lubricants in low-dimensional systems owing to their flatness, high in-plane mechanical strength, and low shear interlayer strength. Yet, the effects of surface topography and surface chemistry on the tribological properties of 2D layers are still unclear. In this work, we performed a comparative investigation of nanoscale tribological properties of ultra-thin highly-ordered PtSe2 layers deposited on the sapphire substrates with the in-plane and out-of-plane crystallographic orientation of the PtSe2 c-axis flakes, and epitaxial PtSe2 layers. PtSe2 c-axis orientation was found to has an impact on the nanotribological, morphological and electrical properties of PtSe2, in particular the change in the alignment of the PtSe2 flakes from vertical (VA) to horizontal (HA) led to the lowering of the coefficient of friction from 0.21 to 0.16. This observation was accompanied by an increase in the root-mean-square surface roughness from 1.0 to 1.7 nm for the HA and VA films, respectively. The epitaxial films showed lower friction caused by lowering adhesion when compared to other investigated films, whereas the friction coefficient was similar to films with HA flakes. The observed trends in nanoscale friction is attributed to a different distribution of PtSe2 structure.
△ Less
Submitted 20 September, 2022; v1 submitted 16 September, 2022;
originally announced September 2022.
High carrier mobility epitaxially aligned PtSe2 films grown by one-zone selenization
Authors:
Michaela Sojkova,
Edmund Dobrocka,
Peter Hutar,
Valeria Taskova,
Lenka Pribusova-Slusna,
Roman Stoklas,
Igor Pis,
Federica Bondino,
Frans Munnik,
Martin Hulman
Abstract:
Few-layer PtSe2 films are promising candidates for applications in high-speed electronics, spintronics and photodetectors. Reproducible fabrication of large-area highly crystalline films is, however, still a challenge. Here, we report the fabrication of epitaxially aligned PtSe2 films using one-zone selenization of pre-sputtered platinum layers. We have studied the influence of the growth conditio…
▽ More
Few-layer PtSe2 films are promising candidates for applications in high-speed electronics, spintronics and photodetectors. Reproducible fabrication of large-area highly crystalline films is, however, still a challenge. Here, we report the fabrication of epitaxially aligned PtSe2 films using one-zone selenization of pre-sputtered platinum layers. We have studied the influence of the growth conditions on the structural and electrical properties of the films prepared from Pt layers with different initial thickness. The best results were obtained for PtSe2 layers grown at elevated temperatures (600 °C). The films exhibit signatures for a long-range in-plane ordering resembling an epitaxial growth. Charge carrier mobility determined by Hall-effect measurements is up to 24 cm2/V.s in these films.
△ Less
Submitted 22 September, 2020; v1 submitted 29 June, 2020;
originally announced June 2020.
