-
Carrier-Density Control of the Quantum-Confined 1$T$-TiSe$_2$ Charge-Density-Wave
Authors:
T. Jaouen,
A. Pulkkinen,
M. Rumo,
G. Kremer,
B. Salzmann,
C. W. Nicholson,
M. -L. Mottas,
E. Giannini,
S. Tricot,
P. Schieffer,
B. Hildebrand,
C. Monney
Abstract:
Using angle-resolved photoemission spectroscopy, combined with first principle and coupled self-consistent Poisson-Schrödinger calculations, we demonstrate that potassium (K) atoms adsorbed on the low-temperature phase of 1$T$-TiSe$_2$ induce the creation of a two-dimensional electron gas (2DEG) and quantum confinement of its charge-density-wave (CDW) at the surface. By further changing the K cove…
▽ More
Using angle-resolved photoemission spectroscopy, combined with first principle and coupled self-consistent Poisson-Schrödinger calculations, we demonstrate that potassium (K) atoms adsorbed on the low-temperature phase of 1$T$-TiSe$_2$ induce the creation of a two-dimensional electron gas (2DEG) and quantum confinement of its charge-density-wave (CDW) at the surface. By further changing the K coverage, we tune the carrier-density within the 2DEG that allows us to nullify, at the surface, the electronic energy gain due to exciton condensation in the CDW phase while preserving a long-range structural order. Our study constitutes a prime example of a controlled exciton-related many-body quantum state in reduced dimensionality by alkali-metal dosing.
△ Less
Submitted 11 May, 2023;
originally announced May 2023.
-
Band structure of the epitaxial Fe/MgO/GaAs(001) tunnel junction studied by X-ray and ultraviolet photoelectron spectroscopy
Authors:
Y. Lu,
J. C. Le Breton,
P. Turban,
B. Lépine,
P. Schieffer,
G. Jézéquel
Abstract:
The electronic band structure in the epitaxial Fe/MgO/GaAs(001) tunnel junction has been studied by X-ray and ultraviolet photoelectron spectroscopy measurements. The Schottky barrier height (SBH) of Fe on MgO/GaAs heterostructure is determined to be 3.3+-0.1eV, which sets the Fe Fermi level about 0.3eV above the GaAs valence band maximum. This SBH is also exactly the same as that measured from Fe…
▽ More
The electronic band structure in the epitaxial Fe/MgO/GaAs(001) tunnel junction has been studied by X-ray and ultraviolet photoelectron spectroscopy measurements. The Schottky barrier height (SBH) of Fe on MgO/GaAs heterostructure is determined to be 3.3+-0.1eV, which sets the Fe Fermi level about 0.3eV above the GaAs valence band maximum. This SBH is also exactly the same as that measured from Fe on MgO monocrystal. After Fe deposition, no band bending change is observed in MgO and GaAs underlayers. On the contrary, Au and Al deposition lead to clear variation of the band bending in both MgO and GaAs layers. This effect is analyzed as a fingerprint of defects states at the MgO/GaAs interface.
△ Less
Submitted 7 April, 2020;
originally announced April 2020.
-
Evidence of Pure Spin-Current Generated by Spin Pum** in Interface Localized States in Hybrid Metal-Silicon-Metal Vertical Structures
Authors:
C. Cerqueira,
J. Y. Qin,
H. Dang,
A. Djeffal,
J. -C. Le Breton,
M. Hehn,
J. -C. Rojas-Sanchez,
X. Devaux,
S. Suire,
S. Migot,
P. Schieffer,
J. -G. Mussot,
P. Laczkowski,
A. Anane,
S. Petit-Watelot,
M. Stoffel,
S. Mangin,
Z. Liu,
B. W. Cheng,
X. F. Han,
H. Jaffrès,
J. -M. George,
Y. Lu
Abstract:
Due to the difficulty to grow high quality semiconductors on ferromagnetic metals, the study of spin diffusion transport in Si was only limited to lateral geometry devices. In this work, by using ultra-high vacuum wafer-bonding technique, we have successfully fabricated metal semiconductor metal CoFeB/MgO/Si/Pt vertical structures. We hereby demonstrate pure spin-current injection and transport in…
▽ More
Due to the difficulty to grow high quality semiconductors on ferromagnetic metals, the study of spin diffusion transport in Si was only limited to lateral geometry devices. In this work, by using ultra-high vacuum wafer-bonding technique, we have successfully fabricated metal semiconductor metal CoFeB/MgO/Si/Pt vertical structures. We hereby demonstrate pure spin-current injection and transport in the perpendicular current flow geometry over a distance larger than 2μm in n-type Si at room temperature. In those experiments, a pure propagating spin-current is generated via ferromagnetic resonance spin-pum** and converted into a measurable voltage by using the inverse spin-Hall effect occurring in the top Pt layer. A systematic study by varying both Si and MgO thicknesses reveals the important role played by the localized states at the MgO/Si interface for the spin-current generation. Proximity effects involving indirect exchange interactions between the ferromagnet and the MgO/Si interface states appears to be a prerequisite to establish the necessary out-of-equilibrium spin-population in Si under the spin-pum** action.
△ Less
Submitted 10 February, 2019;
originally announced February 2019.
-
Induced Work Function Changes at Mg-doped MgO/Ag(001) Interfaces: a Combined Auger Electron Diffraction and Density Functional Study
Authors:
T. Jaouen,
P. Aebi,
S. Tricot,
G. Delhaye,
B. Lépine,
D. Sébilleau,
G. Jézéquel,
P. Schieffer
Abstract:
The properties of MgO/Ag(001) ultrathin films with substitutional Mg atoms in the interface metal layer have been investigated by means of Auger electron diffraction experiments, ultraviolet photoemission spectroscopy, and density functional theory (DFT) calculations. Exploiting the layer-by-layer resolution of the Mg KL_23 L_23 Auger spectra and using multiple scattering calculations, we first de…
▽ More
The properties of MgO/Ag(001) ultrathin films with substitutional Mg atoms in the interface metal layer have been investigated by means of Auger electron diffraction experiments, ultraviolet photoemission spectroscopy, and density functional theory (DFT) calculations. Exploiting the layer-by-layer resolution of the Mg KL_23 L_23 Auger spectra and using multiple scattering calculations, we first determine the interlayer distances as well as the morphological parameters of the MgO/Ag(001) system with and without Mg atoms incorporated at the interface. We find that the Mg atoms incorporation drives a strong distortion of the interface layers and that its impact on the metal/oxide electronic structure is an important reduction of the work function (0.5 eV) related to band-offset variations at the interface. These experimental observations are in very good agreement with our DFT calculations which reproduce the induced lattice distortion and which reveal (through a Bader analysis) that the increase of the interface Mg concentration results in an electron transfer from Mg to Ag atoms of the metallic interface layer. Although the local lattice distortion appears as a consequence of the attractive (repulsive) Coulomb interaction between O2- ions of the MgO interface layer and the nearest positively (negatively) charged Mg (Ag) neighbors of the metallic interface layer, its effect on the work function reduction is only limited. Finally, an analysis of the induced work function changes in terms of charge transfer, rumpling, and electrostatic compression contributions is attempted and reveals that the metal/oxide work function changes induced by interface Mg atoms incorporation are essentially driven by the increase of the electrostatic compression effect.
△ Less
Submitted 25 November, 2014;
originally announced November 2014.
-
Quantitative magnetic imaging at the nanometer scale by ballistic electron magnetic microscopy
Authors:
Marie Hervé,
Sylvain Tricot,
Sophie Guézo,
Gabriel Delhaye,
Bruno Lépine,
Philippe Schieffer,
Pascal Turban
Abstract:
We demonstrate quantitative ballistic electron magnetic microscopy (BEMM) imaging of simple model Fe(001) nanostructures. We use in situ nanostencil shadow mask resistless patterning combined with molecular beam epitaxy deposition to prepare under ultra-high vacuum conditions nanostructured epitaxial Fe/Au/Fe/GaAs(001) spin-valves. In this epitaxial system, the magnetization of the bottom Fe/GaAs(…
▽ More
We demonstrate quantitative ballistic electron magnetic microscopy (BEMM) imaging of simple model Fe(001) nanostructures. We use in situ nanostencil shadow mask resistless patterning combined with molecular beam epitaxy deposition to prepare under ultra-high vacuum conditions nanostructured epitaxial Fe/Au/Fe/GaAs(001) spin-valves. In this epitaxial system, the magnetization of the bottom Fe/GaAs(001) electrode is parallel to the [110] direction, defining accurately the analysis direction for the BEMM experiments. The large hot-electron magnetoresistance of the Fe/Au/Fe/GaAs(001) epitaxial spin-valve allows us to image various stable magnetic configurations on the as-grown Fe(001) microstructures with a high sensitivity, even for small misalignments of both magnetic electrodes. The angular dependence of the hot-electron magnetocurrent is used to convert magnetization maps calculated by micromagnetic simulations into simulated BEMM images. The calculated BEMM images and magnetization rotation profiles show quantitative agreement with experiments and allow us to investigate the magnetic phase diagram of these model Fe(001) microstructures. Finally, magnetic domain reversals are observed under high current density pulses. This opens the way for further BEMM investigations of current-induced magnetization dynamics.
△ Less
Submitted 19 July, 2013;
originally announced July 2013.
-
Layer-resolved study of Mg atom incorporation at MgO/Ag(001) buried interface
Authors:
T. Jaouen,
S. Tricot,
G. Delhaye,
B. Lépine,
D. Sébilleau,
G. Jézéquel,
P. Schieffer
Abstract:
By combining x-ray excited Auger electron diffraction experiments and multiple scattering calculations we reveal a layer-resolved shift for the Mg KL23L23 Auger transition in MgO ultrathin films (4-6 Å) on Ag(001). This resolution is exploited to demonstrate the possibility to control Mg atoms incorporation at the MgO/Ag(001) interface by exposing the MgO films to a Mg flux. A substantial reductio…
▽ More
By combining x-ray excited Auger electron diffraction experiments and multiple scattering calculations we reveal a layer-resolved shift for the Mg KL23L23 Auger transition in MgO ultrathin films (4-6 Å) on Ag(001). This resolution is exploited to demonstrate the possibility to control Mg atoms incorporation at the MgO/Ag(001) interface by exposing the MgO films to a Mg flux. A substantial reduction of the MgO/Ag(001) work function is observed during the exposition phase and reflects, both band-offset variations at the interface and band bending effects in the oxide film.
△ Less
Submitted 26 June, 2013;
originally announced June 2013.
-
Interface bonding of a ferromagnetic/semiconductor junction : a photoemission study of Fe/ZnSe(001)
Authors:
M. Eddrief,
M. Marangolo,
V. H. Etgens,
S. Ustaze,
F. Sirotti,
M. Mulazzi,
G. Panaccione,
D. H. Mosca,
B. Lepine,
P. Schieffer
Abstract:
We have probed the interface of a ferromagnetic/semiconductor (FM/SC) heterojunction by a combined high resolution photoemission spectroscopy and x-ray photoelectron diffraction study. Fe/ZnSe(001) is considered as an example of a very low reactivity interface system and it expected to constitute large Tunnel Magnetoresistance devices. We focus on the interface atomic environment, on the microsc…
▽ More
We have probed the interface of a ferromagnetic/semiconductor (FM/SC) heterojunction by a combined high resolution photoemission spectroscopy and x-ray photoelectron diffraction study. Fe/ZnSe(001) is considered as an example of a very low reactivity interface system and it expected to constitute large Tunnel Magnetoresistance devices. We focus on the interface atomic environment, on the microscopic processes of the interface formation and on the iron valence-band. We show that the Fe contact with ZnSe induces a chemical conversion of the ZnSe outermost atomic layers. The main driving force that induces this rearrangement is the requirement for a stable Fe-Se bonding at the interface and a Se monolayer that floats at the Fe growth front. The released Zn atoms are incorporated in substitution in the Fe lattice position. This formation process is independent of the ZnSe surface termination (Zn or Se). The Fe valence-band evolution indicates that the d-states at the Fermi level show up even at submonolayer Fe coverage but that the Fe bulk character is only recovered above 10 monolayers. Indeed, the Fe 1-band states, theoretically predicted to dominate the tunneling conductance of Fe/ZnSe/Fe junctions, are strongly modified at the FM/SC interface.
△ Less
Submitted 31 January, 2006;
originally announced January 2006.
