-
Characterisation of plastic scintillator paddles and lightweight MWPCs for the MID subsystem of ALICE 3
Authors:
Ruben Alfaro,
Mauricio Alvarado Hernández,
Gyula Bencédi,
Juan Carlos Cabanillas Noris,
Marco Antonio Díaz Maldonado,
Carlos Duarte Galvan,
Arturo Fernández Téllez,
Gergely Gábor Barnaföldi,
Ádám Gera,
Varlen Grabsky,
Gergő Hamar,
Gerardo Herrera Corral,
Ildefonso León Monzón,
Josué Martínez García,
Mario Iván Martínez Hernandez,
Jesús Eduardo Muñoz Méndez,
Richárd Nagy,
Rafael Ángel Narcio Laveaga,
Antonio Ortiz,
Mario Rodríguez Cahuantzi,
Solangel Rojas Torres,
Timea Szollosova,
Miguel Enrique Patiño Salazar,
Jared Pazarán García,
Hector David Regules Medel
, et al. (7 additional authors not shown)
Abstract:
The ALICE collaboration is proposing a completely new detector, ALICE 3, for operation during the LHC Runs 5 and 6. One of the ALICE~3 subsystems is the Muon IDentifier detector (MID), which has to be optimised to be efficient for the reconstruction of $J/ψ$ at rest (muons down to $p_{\rm T}\approx1.5$ GeV/$c$) for $|η|<1.3$. Given the modest particle flux expected in the MID of a few Hz/cm$^2$, t…
▽ More
The ALICE collaboration is proposing a completely new detector, ALICE 3, for operation during the LHC Runs 5 and 6. One of the ALICE~3 subsystems is the Muon IDentifier detector (MID), which has to be optimised to be efficient for the reconstruction of $J/ψ$ at rest (muons down to $p_{\rm T}\approx1.5$ GeV/$c$) for $|η|<1.3$. Given the modest particle flux expected in the MID of a few Hz/cm$^2$, technologies like plastic scintillator bars ($\approx1$ m length) equipped with wavelength-shifting fibers and silicon photomultiplier readout, and lightweight Multi-Wire Proportional Chambers (MWPCs) are under investigation. To this end, different plastic scintillator paddles and MWPCs were studied at the CERN T10 test beam facility. This paper reports on the performance of the scintillator prototypes tested at different beam momenta (from 0.5 GeV/$c$ up to 6 GeV/$c$) and positions (horizontal, vertical, and angular scans). The MWPCs were tested at different momenta (from 0.5 GeV/$c$ to 10 GeV/$c$) and beam intensities, their efficiency and position resolutions were verified beyond the particle rates expected with the MID in ALICE 3.
△ Less
Submitted 16 February, 2024; v1 submitted 9 January, 2024;
originally announced January 2024.
-
Performance of ALICE AD modules in the CERN PS test beam
Authors:
M. Broz,
J. C. Cabanillas Noris,
E. Calvo Villar,
C. Duarte Galvan,
E. Endress,
L. G. Espinoza Beltran,
A. Fernandez Tellez,
D. Finogeev,
A. M. Gago,
G. Herrera Corral,
T. Kim,
A. Kurepin,
A. B. Kurepin,
N. Kurepin,
I. Leon Monzon,
M. I. Martinez Hernandez,
C. Mayer,
M. M. Mieskolainen,
R. Orava,
L. A. Perez Moreno,
J. -P. Revol,
M. Rodriguez Cahuantzi,
S. Rojas Torres,
D. Serebryakov,
A. Shabanov
, et al. (2 additional authors not shown)
Abstract:
Two modules of the AD detector have been studied with the test beam at the T10 facility at CERN. The AD detector is made of scintillator pads read out by wave-length shifters (WLS)coupled to clean fibres that carry the produced light to photo-multiplier tubes (PMTs). In ALICE the AD is used to trigger and study the physics of diffractive and ultra-peripheral collisions as well as for a variety of…
▽ More
Two modules of the AD detector have been studied with the test beam at the T10 facility at CERN. The AD detector is made of scintillator pads read out by wave-length shifters (WLS)coupled to clean fibres that carry the produced light to photo-multiplier tubes (PMTs). In ALICE the AD is used to trigger and study the physics of diffractive and ultra-peripheral collisions as well as for a variety of technical tasks like beam-gas background monitoring or as a luminometer. The position dependence of the modules' efficiency has been measured and the effect of hits on the WLS or PMTs has been evaluated. The charge deposited by pions and protons has been measured at different momenta of the test beam. The time resolution is determined as a function of the deposited charge. These results are important ingredients to better understand the AD detector, to benchmark the corresponding simulations, and very importantly they served as a baseline for a similar device, the Forward Diffractive Detector (FDD), being currently built and that will be in operation in ALICE during the LHC Runs 3 and 4.
△ Less
Submitted 26 June, 2020;
originally announced June 2020.
-
LHC Forward Physics
Authors:
K. Akiba,
M. Akbiyik,
M. Albrow,
M. Arneodo,
V. Avati,
J. Baechler,
O. Villalobos Baillie,
P. Bartalini,
J. Bartels,
S. Baur,
C. Baus,
W. Beaumont,
U. Behrens,
D. Berge,
M. Berretti,
E. Bossini,
R. Boussarie,
S. Brodsky,
M. Broz,
M. Bruschi,
P. Bussey,
W. Byczynski,
J. C. Cabanillas Noris,
E. Calvo Villar,
A. Campbell
, et al. (162 additional authors not shown)
Abstract:
The goal of this report is to give a comprehensive overview of the rich field of forward physics, with a special attention to the topics that can be studied at the LHC. The report starts presenting a selection of the Monte Carlo simulation tools currently available, chapter 2, then enters the rich phenomenology of QCD at low, chapter 3, and high, chapter 4, momentum transfer, while the unique scat…
▽ More
The goal of this report is to give a comprehensive overview of the rich field of forward physics, with a special attention to the topics that can be studied at the LHC. The report starts presenting a selection of the Monte Carlo simulation tools currently available, chapter 2, then enters the rich phenomenology of QCD at low, chapter 3, and high, chapter 4, momentum transfer, while the unique scattering conditions of central exclusive production are analyzed in chapter 5. The last two experimental topics, Cosmic Ray and Heavy Ion physics are presented in the chapter 6 and 7 respectively. Chapter 8 is dedicated to the BFKL dynamics, multiparton interactions, and saturation. The report ends with an overview of the forward detectors at LHC. Each chapter is correlated with a comprehensive bibliography, attempting to provide to the interested reader with a wide opportunity for further studies.
△ Less
Submitted 9 December, 2017; v1 submitted 15 November, 2016;
originally announced November 2016.
