-
Dose rate dependence of TID damage to 65 nm CMOS transistors in X-ray irradiations of the ATLAS ITk Pixel ASIC (ITkPix)
Authors:
Daniela Bortoletto,
Aleksandra Dimitrievska,
Maurice Garcia-Sciveres,
Timon Heim,
Maria Mironova,
Richard Plackett,
Ian Shipsey,
Junwen Xiong
Abstract:
The ATLAS Inner Tracker (ITk) upgrade for the High-Luminosity LHC (HL-LHC) requires a radiation-tolerant pixel readout chip, which must withstand a total ionising dose (TID) of up to 1 Grad. The readout ASIC for the ITk upgrade has been designed by the RD53 collaboration using 65 nm CMOS technology. In order to characterise the radiation tolerance of the chip digital logic, the RD53 ASICs include…
▽ More
The ATLAS Inner Tracker (ITk) upgrade for the High-Luminosity LHC (HL-LHC) requires a radiation-tolerant pixel readout chip, which must withstand a total ionising dose (TID) of up to 1 Grad. The readout ASIC for the ITk upgrade has been designed by the RD53 collaboration using 65 nm CMOS technology. In order to characterise the radiation tolerance of the chip digital logic, the RD53 ASICs include ring oscillators, which can be used to measure gate delay degradation. Extensive X-ray irradiation studies of the ring oscillators have been performed on the ITk Pixel pre-production readout ASIC, ITkPixV1. A dependence of radiation damage on dose rate has been observed in 65 nm CMOS technology. This paper aims to quantify the dose rate dependence of TID damage to the ITkPix ring oscillators and, therefore, the ITkPix ASIC digital logic. X-ray irradiations at different dose rates between 20 krad/h and 30 Mrad/h are compared. A dose rate dependence is observed, with 2-3 times more damage at the lowest dose rate of 20 krad/h, compared to 4 Mrad/h. The dose rate dependence was also observed to be dependent on transistor size and type.
△ Less
Submitted 16 April, 2024;
originally announced April 2024.
-
A High Pressure Time Projection Chamber with Optical Readout
Authors:
Alexander Deisting,
Abigail Victoria Waldron,
Edward Atkin,
Gary Barker,
Anastasia Basharina-Freshville,
Christopher Betancourt,
Steven Boyd,
Dominic Brailsford,
Zachary Chen-Wishart,
Linda Cremonesi,
Adriana Dias,
Patrick Dunne,
Jennifer Haigh,
Philip Hamacher-Baumann,
Sebastian Jones,
Asher Kaboth,
Alexander Korzenev,
William Ma,
Philippe Mermod,
Maria Mironova,
Jocelyn Monroe,
Ryan Nichol,
Toby Nonnenmacher,
Jaroslaw Nowak,
William Parker
, et al. (11 additional authors not shown)
Abstract:
Measurements of proton-nucleus scattering and high resolution neutrino-nucleus interaction imaging are key to reduce neutrino oscillation systematic uncertainties in future experiments. A High Pressure Time Projection Chamber (HPTPC) prototype has been constructed and operated at Royal Holloway University of London and CERN as a first step in the development of a HPTPC capable of performing these…
▽ More
Measurements of proton-nucleus scattering and high resolution neutrino-nucleus interaction imaging are key to reduce neutrino oscillation systematic uncertainties in future experiments. A High Pressure Time Projection Chamber (HPTPC) prototype has been constructed and operated at Royal Holloway University of London and CERN as a first step in the development of a HPTPC capable of performing these measurements as part of a future long-baseline neutrino oscillation experiment such as the Deep Underground Neutrino Experiment. In this paper we describe the design and operation of the prototype HPTPC with an argon based gas mixture. We report on the successful hybrid charge and optical readout, using four CCD cameras, of signals from Am-241 sources.
△ Less
Submitted 2 June, 2021; v1 submitted 12 February, 2021;
originally announced February 2021.
-
Off-Axis Characterisation of the CERN T10 Beam for low Momentum Proton Measurements with a High Pressure Gas Time Projection Chamber
Authors:
S. B. Jones,
T. S. Nonnenmacher,
E. Atkin,
G. J. Barker,
A. Basharina-Freshville,
C. Betancourt,
S. B. Boyd,
D. Brailsford,
Z. Chen-Wishart,
L. Cremonesi,
A. Deisting,
A. Dias,
P. Dunne,
J. Haigh,
P. Hamacher-Baumann,
A. Kaboth,
A. Korzenev,
W. Ma,
P. Mermod,
M. Mironova,
J. Monroe,
R. Nichol,
J. Nowak,
W. Parker,
H. Ritchie-Yates
, et al. (11 additional authors not shown)
Abstract:
We present studies of proton fluxes in the T10 beamline at CERN. A prototype high pressure gas time projection chamber (TPC) was exposed to the beam of protons and other particles, using the 0.8 GeV/c momentum setting in T10, in order to make cross section measurements of low energy protons in argon. To explore the energy region comparable to hadrons produced by GeV-scale neutrino interactions at…
▽ More
We present studies of proton fluxes in the T10 beamline at CERN. A prototype high pressure gas time projection chamber (TPC) was exposed to the beam of protons and other particles, using the 0.8 GeV/c momentum setting in T10, in order to make cross section measurements of low energy protons in argon. To explore the energy region comparable to hadrons produced by GeV-scale neutrino interactions at oscillation experiments, i.e., near 0.1 GeV of kinetic energy, methods of moderating the T10 beam were employed: the dual technique of moderating the beam with acrylic blocks and measuring scattered protons off the beam axis was used to decrease the kinetic energy of incident protons, as well as change the proton/minimum ionising particle (MIP) composition of the incident flux. Measurements of the beam properties were made using time of flight systems upstream and downstream of the TPC. The kinetic energy of protons reaching the TPC was successfully changed from $\sim0.3$ GeV without moderator blocks to less than 0.1 GeV with four moderator blocks (40 cm path length). The flux of both protons and MIPs off the beam axis was increased. The ratio of protons to MIPs vary as a function of the off-axis angle allowing for possible optimisation of the detector to select the type of required particles. Simulation informed by the time of flight measurements show that with four moderator blocks placed in the beamline, ($5.6 \pm 0.1$) protons with energies below 0.1 GeV per spill traversed the active TPC region. Measurements of the beam composition and energy are presented.
△ Less
Submitted 30 July, 2020;
originally announced July 2020.
-
Measurement of the relative response of TowerJazz Mini-MALTA CMOS prototypes at Diamond Light Source
Authors:
Maria Mironova,
Kaloyan Metodiev,
Phil Allport,
Ivan Berdalovic,
Daniela Bortoletto,
Craig Buttar,
Roberto Cardella,
Valerio Dao,
Mateusz Dyndal,
Patrick Freeman,
Leyre Flores Sanz de Acedo,
Laura Gonella,
Thanushan Kugathasan,
Heinz Pernegger,
Francesco Piro,
Richard Plackett,
Petra Riedler,
Abhishek Sharma,
Enrico Junior Schioppa,
Ian Shipsey,
Carlos Solans Sanchez,
Walter Snoeys,
Hakan Wennloef,
Daniel Weatherill,
Daniel Wood
, et al. (1 additional authors not shown)
Abstract:
This paper outlines the results of investigations into the effects of radiation damage in the mini-MALTA prototype. Measurements were carried out at Diamond Light Source using a micro-focus X-ray beam, which scanned across the surface of the device in 2 $\mathrm{μm}$ steps. This allowed the in-pixel photon response to be measured directly with high statistics. Three pixel design variations were co…
▽ More
This paper outlines the results of investigations into the effects of radiation damage in the mini-MALTA prototype. Measurements were carried out at Diamond Light Source using a micro-focus X-ray beam, which scanned across the surface of the device in 2 $\mathrm{μm}$ steps. This allowed the in-pixel photon response to be measured directly with high statistics. Three pixel design variations were considered: one with the standard continuous $\mathrm{n^-}$ layer layout and front-end, and extra deep p-well and $\mathrm{n^-}$ gap designs with a modified front-end. Five chips were measured: one unirradiated, one neutron irradiated, and three proton irradiated.
△ Less
Submitted 2 October, 2019; v1 submitted 18 September, 2019;
originally announced September 2019.
-
Earth-Moon VLBI project. Modeling of scientific outcome
Authors:
Sergei L. Kurdubov,
Dmitry A. Pavlov,
Svetlana M. Mironova,
Sergey A. Kaplev
Abstract:
Modern radio astrometry has reached the limit of the resolution that is determined by the size of the Earth. The only way to overcome that limit is to create the radio telescopes outside our planet. It is proposed to build an autonomous remote-controlled radio observatory on the Moon. Working together with the existing radio telescopes on Earth in the VLBI mode, the new observatory will form an in…
▽ More
Modern radio astrometry has reached the limit of the resolution that is determined by the size of the Earth. The only way to overcome that limit is to create the radio telescopes outside our planet. It is proposed to build an autonomous remote-controlled radio observatory on the Moon. Working together with the existing radio telescopes on Earth in the VLBI mode, the new observatory will form an interferometer baseline up to 410000 km, enhancing the present astrometric and geodetic capabilities of VLBI. We perform numerical simulations of Earth-Moon VLBI observations operating simultaneously with the international VLBI network. It is shown that these observations will significantly improve the precision of determination of Moon's orbital motion, libration angles, ICRF, and relativistic parameters.
△ Less
Submitted 20 March, 2019; v1 submitted 11 March, 2019;
originally announced March 2019.
-
Automatic Selection of CDS Timing Parameters
Authors:
Daniel P Weatherill,
Ian Shipsey,
Kirk Arndt,
Richard Plackett,
Daniel Wood,
Kaloyan Metodiev,
Maria Mironova,
Daniela Bortoletto,
Nicolas Demetriou
Abstract:
CDS is a process used in many CCD readout systems to cancel the reset noise component that would otherwise dominate. CDS processing typically consists of subtracting the integrated video signal during a "signal" period from that during a "reset" period. The response of this processing depends therefore on the shape of the video signal with respect to the integration bounds. In particular, the amou…
▽ More
CDS is a process used in many CCD readout systems to cancel the reset noise component that would otherwise dominate. CDS processing typically consists of subtracting the integrated video signal during a "signal" period from that during a "reset" period. The response of this processing depends therefore on the shape of the video signal with respect to the integration bounds. In particular, the amount of noise appearing in the final image and the linearity of the pixel value with signal charge are affected by the choice of the CDS timing intervals. In this paper, we use a digital CDS readout system which highly oversamples the video signal (as compared with the pixel rate) to reconstruct pixel values for different CDS timings using identical raw video signal data. We use this technique to develop insights into optimal strategy for selecting CDS timings both in the digital case (where the raw video signal may be available), and in the general case where it is not. In particular, we show that the linearity of the CDS operation allows subtraction of the raw video signals of pixels in bias images from those in illuminated images to directly show the effects of CDS processing on the final (subtracted) pixel values.
△ Less
Submitted 23 July, 2019; v1 submitted 11 February, 2019;
originally announced February 2019.
-
Negative differential photoconductance in InGaN/GaN multiple-quantum-well structures
Authors:
M. V. Baranovskiy,
G. F. Glinskii,
M. S. Mironova
Abstract:
The photocurrent and the small-signal photoconductance of InGaN/GaN multiple-quantum-well structures were studied at the temperature range from 10 to 300 K. The optical excitation was carried out at the quantum wells intrinsic absorption wavelengths. Regardless of the temperature the experimental plots of direct photocurrent vs. reverse voltage were step-like, which is related to the sequential qu…
▽ More
The photocurrent and the small-signal photoconductance of InGaN/GaN multiple-quantum-well structures were studied at the temperature range from 10 to 300 K. The optical excitation was carried out at the quantum wells intrinsic absorption wavelengths. Regardless of the temperature the experimental plots of direct photocurrent vs. reverse voltage were step-like, which is related to the sequential quantum wells passage from quasi-neutrality into the p-n-junction space charge region. In addition, under optical excitation near the quantum wells material absorption edge we observed the photocurrent declines with increasing reverse bias, i.e. the negative differential photoconductance. This phenomenon is associated with a blue shift of the InGaN quantum well absorption edge arising due to compensation of its build-in piezoelectric field by the p-n-junction electric field. Furthermore, it was experimentally shown that each quantum well corresponds to two peaks in the small-signal photoconductance vs. reverse voltage dependence. The temperature changes in the amplitude and position of these peaks indicate that they probably related to the charge carriers thermal emission and thermally activated tunneling from the quantum well.
△ Less
Submitted 9 April, 2014;
originally announced April 2014.
-
Electronic Structure and Resonant X-ray Emission Spectra of Carbon Shells of Iron Nanoparticles
Authors:
V. R. Galakhov,
S. N. Shamin,
E. M. Mironova,
M. A. Uimin,
A. Ye. Yermakov,
D. W. Boukhvalov
Abstract:
The electronic structure of carbon shells of carbon encapsulated iron nanoparticles carbon encapsulated Fe@C has been studied by X-ray resonant emission and X-ray absorption spectroscopy. The recorded spectra have been compared to the density functional calculations of the electronic structure of graphene. It has been shown that an Fe@C carbon shell can be represented in the form of several graphe…
▽ More
The electronic structure of carbon shells of carbon encapsulated iron nanoparticles carbon encapsulated Fe@C has been studied by X-ray resonant emission and X-ray absorption spectroscopy. The recorded spectra have been compared to the density functional calculations of the electronic structure of graphene. It has been shown that an Fe@C carbon shell can be represented in the form of several graphene layers with Stone-Wales defects. The dispersion of energy bands of Fe@C has been examined using the measured C Ka resonant X-ray emission spectra.
△ Less
Submitted 19 March, 2013;
originally announced March 2013.
