-
Automated detection and map** of crystal tilt using thermal diffuse scattering in transmission electron microscopy
Authors:
Mauricio Cattaneo,
Knut Müller-Caspary,
Juri Barthel,
Katherine E. Mac Arthur,
Nicolas Gauquelin,
Marta Lipinska-Chwalek,
Johan Verbeeck,
Leslie J. Allen,
Rafal E. Dunin-Borkowski
Abstract:
Quantitative interpretation of transmission electron microscopy (TEM) data of crystalline specimens often requires the accurate knowledge of the local crystal orientation. A method is presented which exploits momentum-resolved scanning TEM (STEM) data to determine the local mistilt from a major zone axis. It is based on a geometric analysis of Kikuchi bands within a single diffraction pattern, yie…
▽ More
Quantitative interpretation of transmission electron microscopy (TEM) data of crystalline specimens often requires the accurate knowledge of the local crystal orientation. A method is presented which exploits momentum-resolved scanning TEM (STEM) data to determine the local mistilt from a major zone axis. It is based on a geometric analysis of Kikuchi bands within a single diffraction pattern, yielding the centre of the Laue circle. Whereas the approach is not limited to convergent illumination, it is here developed using unit-cell averaged diffraction patterns corresponding to high-resolution STEM settings. In simulation studies, an accuracy of approximately 0.1mrad is found. The method is implemented in automated software and applied to crystallographic tilt and in-plane rotation map** in two experimental cases. In particular, orientation maps of high-Mn steel and an epitaxially grown La$_{\text{0.7}}$Sr$_{\text{0.3}}$MnO$_{\text{3}}$-SrTiO$_{\text{3}}$ interface are presented. The results confirm the estimates of the simulation study and indicate that tilt map** can be performed consistently over a wide field of view with diameters well above 100nm at unit cell real space sampling.
△ Less
Submitted 20 June, 2024;
originally announced June 2024.
-
Influence of chemical composition on the room temperature plas-ticity of C15 Ca-Al-Mg Laves phases
Authors:
Martina Freund,
Zhuocheng Xie,
Pei-Ling Sun,
Lukas Berners,
Joshua Spille,
Hexin Wan,
Carsten Thomas,
Michael Feuerbacher,
Marta Lipinska-Chwalek,
Joachim Mayer,
Sandra Korte-Kerzel
Abstract:
The influence of chemical composition changes on the room temperature mechanical proper-ties in the C15 CaAl2 Laves phase were investigated in two off-stoichiometric compositions with 5.7 at.-% Mg addition (Ca33Al61Mg6) and 10.8 at.-% Mg and 3.0 at.-% Ca addition (Ca36Al53Mg11) and compared to the stoichiometric (Ca33Al67) composition. Cubic Ca-Al-Mg Laves phases with multiple crystallographic ori…
▽ More
The influence of chemical composition changes on the room temperature mechanical proper-ties in the C15 CaAl2 Laves phase were investigated in two off-stoichiometric compositions with 5.7 at.-% Mg addition (Ca33Al61Mg6) and 10.8 at.-% Mg and 3.0 at.-% Ca addition (Ca36Al53Mg11) and compared to the stoichiometric (Ca33Al67) composition. Cubic Ca-Al-Mg Laves phases with multiple crystallographic orientations were characterised and deformed using nanoindentation. The hardness and indentation modulus were measured to be 4.1 +- 0.3 GPa and 71.3 +- 1.5 GPa for Ca36Al53Mg11, 4.6 +- 0.2 GPa and 80.4 +- 3.8 GPa for Ca33Al61Mg6 and 4.9 +- 0.3 GPa and 85.5 +- 4.0 GPa for Ca33Al67, respectively. The resulting surface traces as well as slip and crack planes, were distinguished on the indentation surfac-es, revealing the activation of several different {11n} slip systems, as further confirmed by conventional transmission electron microscopic observations. Additionally, the deformation mechanisms and corresponding energy barriers of activated slip systems were evaluated by atomistic simulations.
△ Less
Submitted 20 March, 2024;
originally announced March 2024.
-
Phase stability and defect studies of Mg-based Laves phases using defect phase diagrams
Authors:
A. Tehranchi,
M. Lipinska-Chwalek,
J. Mayer,
J. Neugebauer,
T. Hickel
Abstract:
Laves phases often form as secondary phases in metallic alloys and have a significant effect on their structural properties. Thus, phase stability studies for these chemically and structurally complex phases in addition to mechanical behavior studies are of great interest. In this work, we use the concept of metastable bulk phase and defect phase diagrams to augment the understanding of the bulk p…
▽ More
Laves phases often form as secondary phases in metallic alloys and have a significant effect on their structural properties. Thus, phase stability studies for these chemically and structurally complex phases in addition to mechanical behavior studies are of great interest. In this work, we use the concept of metastable bulk phase and defect phase diagrams to augment the understanding of the bulk phase and defect phase stability in Laves phases in Mg-based alloys. In this way, we resolve the discrepancy between bulk phase diagrams and experimental observations regarding the formation of Mg-rich C14 and Al-rich C15 Laves phases in MgAlCa alloys at moderate temperatures. Moreover, the effect of the thermodynamic state of alloys on the competition between solute-rich hcp-like planar defects and stoichiometric basal stacking faults is clarified, which determines the brittleness of these alloys. \end{abstract}
△ Less
Submitted 16 March, 2023;
originally announced March 2023.
-
Co-deformation Between the Metallic Matrix and Intermetallic Phases in a Creep-Resistant Mg-3.68Al-3.8Ca Alloy
Authors:
M. Zubair,
S. Sandlöbes-Haut,
M. Lipińska-Chwałek,
M. A. Wollenweber,
C. Zehnder,
J. Mayer,
J. S. K-L. Gibson,
S. Korte-Kerzel
Abstract:
The microstructure of Mg-Al-Ca alloys consists of a hard intra- and intergranular eutectic Laves phase network embedded in a soft $α$-Mg matrix. For such heterogeneous microstructures, the mechanical response and co-deformation of both phases under external load are not yet fully understood. We therefore used nano- and microindentation in combination with electron microscopy to study the deformati…
▽ More
The microstructure of Mg-Al-Ca alloys consists of a hard intra- and intergranular eutectic Laves phase network embedded in a soft $α$-Mg matrix. For such heterogeneous microstructures, the mechanical response and co-deformation of both phases under external load are not yet fully understood. We therefore used nano- and microindentation in combination with electron microscopy to study the deformation behaviour of an Mg-3.68Al-3.8Ca alloy.
We found that the hardness of the Mg$_2$Ca phase was significantly larger than the $α$-Mg phase and stays constant within the measured temperature range. The strain rate sensitivity of the softer $α$-Mg phase and of the interfaces increased while activation volume decreased with temperature. The creep deformation of the Mg$_2$Ca Laves phase was significantly lower than the $α$-Mg phase at 170 $^{\circ}$C. Moreover, the deformation zone around and below microindents depends on the matrix orientation and is influenced by the presence of Laves phases. Most importantly, slip transfer from the $α$-Mg phase to the (Mg,Al)$_2$Ca Laves phase occurred, carried by the basal planes. Based on the observed orientation relationship and active slip systems, a slip transfer mechanism from the soft $α$-Mg phase to the hard Laves phase is proposed. Further, we present implications for future alloy design strategies.
△ Less
Submitted 30 August, 2021;
originally announced August 2021.
-
Curvature-mediated spin textures in magnetic multi-layered nanotubes
Authors:
Elisabeth Josten,
David Raftrey,
Aurelio Hierro-Rodriguez,
Andrea Sorrentino,
Lucia Aballe,
Marta Lipińska-Chwałek,
Thomas Jansen,
Katja Höflich,
Hanno Kröncke,
Catherine Dubourdieu,
Daniel E. Bürgler,
Joachim Mayer,
Peter Fischer
Abstract:
The scientific and technological exploration of artificially designed three-dimensional magnetic nanostructures opens the path to exciting novel physical phenomena, originating from the increased complexity in spin textures, topology, and frustration in three dimensions. Theory predicts that the equilibrium magnetic ground state of two-dimensional systems which reflects the competition between sym…
▽ More
The scientific and technological exploration of artificially designed three-dimensional magnetic nanostructures opens the path to exciting novel physical phenomena, originating from the increased complexity in spin textures, topology, and frustration in three dimensions. Theory predicts that the equilibrium magnetic ground state of two-dimensional systems which reflects the competition between symmetric (Heisenberg) and antisymmetric (Dzyaloshinskii-Moriya interaction (DMI)) exchange interaction is significantly modified on curved surfaces when the radius of local curvature becomes comparable to fundamental magnetic length scales. Here, we present an experimental study of the spin texture in an 8 nm thin magnetic multilayer with growth-induced in-plane anisotropy and DMI deposited onto the curved surface of a 1.8 μm long non-magnetic carbon nanowire with a 67 nm radius. Using magnetic soft x-ray tomography the three-dimensional spin configuration in this nanotube was retrieved with about 30nm spatial resolution. The transition between two vortex configurations on the two ends of the nanotube with opposite circulation occurs through a domain wall that is aligned at an inclined angle relative to the wire axis. Three-dimensional micromagnetic simulations support the experimental observations and represent a visualization of the curvature-mediated DMI. They also allow a quantitative estimate of the DMI value for the magnetic multilayered nanotube.
△ Less
Submitted 24 March, 2021;
originally announced March 2021.
-
Exploring the transfer of plasticity across Laves phase interfaces in a dual phase magnesium alloy
Authors:
Julien Guénolé,
Muhammad Zubair,
Swagata Roy,
Zhuocheng Xie,
Marta Lipińska-Chwałek,
Stefanie Sandlöbes-Haut,
Sandra Korte-Kerzel
Abstract:
The mechanical behaviour of Mg-Al alloys can be largely improved by the formation of an intermetallic Laves phase skeleton, in particular the creep strength. Recent nanomechanical studies revealed plasticity by dislocation glide in the (Mg,Al)$_2$Ca Laves phase, even at room temperature. As strengthening skeleton, this phase remains, however, brittle at low temperature. In this work, we present ex…
▽ More
The mechanical behaviour of Mg-Al alloys can be largely improved by the formation of an intermetallic Laves phase skeleton, in particular the creep strength. Recent nanomechanical studies revealed plasticity by dislocation glide in the (Mg,Al)$_2$Ca Laves phase, even at room temperature. As strengthening skeleton, this phase remains, however, brittle at low temperature. In this work, we present experimental evidence of slip transfer from the Mg matrix to the (Mg,Al)$_2$Ca skeleton at room temperature and explore associated mechanisms by means of atomistic simulations. We identify two possible mechanisms for transferring Mg basal slip into Laves phases depending on the crystallographic orientation: a direct and an indirect slip transfer triggered by full and partial dislocations, respectively. Our experimental and numerical observations also highlight the importance of interfacial sliding that can prevent the transfer of the plasticity from one phase to the other.
△ Less
Submitted 12 February, 2021; v1 submitted 11 November, 2020;
originally announced November 2020.
