-
Performance enhancement of electrocatalytic hydrogen evolution through coalescence-induced bubble dynamics
Authors:
Aleksandr Bashkatov,
Sunghak Park,
Çayan Demirkır,
Jeffery A. Wood,
Marc T. M. Koper,
Detlef Lohse,
Dominik Krug
Abstract:
The evolution of electrogenerated gas bubbles during water electrolysis can significantly hamper the overall process efficiency. Promoting the departure of electrochemically generated bubbles during (water) electrolysis is therefore beneficial. For a single bubble, a departure from the electrode surface occurs when buoyancy wins over the downward-acting forces (e.g. contact, Marangoni, and electri…
▽ More
The evolution of electrogenerated gas bubbles during water electrolysis can significantly hamper the overall process efficiency. Promoting the departure of electrochemically generated bubbles during (water) electrolysis is therefore beneficial. For a single bubble, a departure from the electrode surface occurs when buoyancy wins over the downward-acting forces (e.g. contact, Marangoni, and electric forces). In this work, the dynamics of a pair of H$_2$ bubbles produced during hydrogen evolution reaction in 0.5 M H$_2$SO$_4$ using dual platinum micro-electrode system is systematically studied by varying the electrode distance and the cathodic potential. By combining high-speed imaging and electrochemical analysis, we demonstrate the importance of bubble-bubble interactions for the departure process. We show that bubble coalescence may lead to substantially earlier bubble departure as compared to buoyancy effects alone, resulting in considerably higher reaction rates at constant potential. However, due to continued mass input and conservation of momentum repeated coalescence events with bubbles close to the electrode may drive departed bubbles back to the surface beyond a critical current, which increases with the electrode spacing. The latter leads to the resumption of bubble growth near the electrode surface, followed by buoyancy-driven departure. While less favourable at small electrode spacing, this configuration proves to be very beneficial at larger separations increasing the mean current up to 2.4 times compared to a single electrode under the conditions explored in this study.
△ Less
Submitted 12 February, 2024;
originally announced February 2024.
-
Surface-specific vibrational spectroscopy of interfacial water reveals large pH change near graphene electrode at low current densities
Authors:
Yongkang Wang,
Takakazu Seki,
Xuan Liu,
Xiaoqing Yu,
Chun-Chieh Yu,
Katrin F. Domke,
Johannes Hunger,
Marc T. M. Koper,
Yunfei Chen,
Yuki Nagata,
Mischa Bonn
Abstract:
Molecular-level insight into interfacial water at buried electrode interfaces is essential in elucidating many phenomena of electrochemistry, but spectroscopic probing of the buried interfaces remains challenging. Here, using surface-specific vibrational spectroscopy, we probe and identify the interfacial water orientation and interfacial electric field at the calcium fluoride (CaF2)-supported ele…
▽ More
Molecular-level insight into interfacial water at buried electrode interfaces is essential in elucidating many phenomena of electrochemistry, but spectroscopic probing of the buried interfaces remains challenging. Here, using surface-specific vibrational spectroscopy, we probe and identify the interfacial water orientation and interfacial electric field at the calcium fluoride (CaF2)-supported electrified graphene/water interface under applied potentials. Our data shows that the water orientation changes drastically at negative potentials (<-0.03 V vs. Pd/H2), from O-H group pointing down towards bulk solution to pointing up away from the bulk solution, which arises from charging/discharging not of the graphene but of the CaF2 substrate. The potential-dependent spectra are nearly identical to the pH-dependent spectra, evidencing that the applied potentials change the local pH (more than five pH units) near the graphene electrode even at a current density below 1 microamp per square centimeter. Our work provides molecular-level insights into the dissociation and reorganization of interfacial water on an electrode/electrolyte interface.
△ Less
Submitted 5 October, 2022;
originally announced October 2022.
-
Ni modified Fe3O4(001) surface as a simple model system for understanding the Oxygen Evolution Reaction
Authors:
Francesca Mirabella,
Matthias Muellner,
Thomas Touzalin,
Michele Riva,
Zdenek Jakub,
Florian Kraushofer,
Michael Schmid,
Marc T. M. Koper,
Gareth S. Parkinson,
Ulrike Diebold
Abstract:
Electrochemical water splitting is an environmentally friendly technology to store renewable energy in the form of chemical fuels. Among the earth-abundant first-row transition metal-based catalysts, mixed Ni-Fe oxides have shown promising performance for effective and low-cost catalysis of the oxygen evolution reaction (OER) in alkaline media, but the synergistic roles of Fe and Ni cations in the…
▽ More
Electrochemical water splitting is an environmentally friendly technology to store renewable energy in the form of chemical fuels. Among the earth-abundant first-row transition metal-based catalysts, mixed Ni-Fe oxides have shown promising performance for effective and low-cost catalysis of the oxygen evolution reaction (OER) in alkaline media, but the synergistic roles of Fe and Ni cations in the OER mechanism remain unclear. In this work, we report how addition of Ni changes the reactivity of a model iron oxide catalyst, based on Ni deposited on and incorporated in a magnetite Fe3O4 (001) single crystal, using a combination of surface science techniques in ultra-high-vacuum such as low energy electron diffraction (LEED), x-rays photoelectron spectroscopy (XPS), low energy ion scattering (LEIS), and scanning tunneling microscopy (STM), as well as atomic force microscopy (AFM) in air, and electrochemical methods such cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) in alkaline media. A significant improvement in the OER activity is observed when the top surface presents an Fe:Ni composition ratio in the range 20-40%, which is in good agreement with what has been observed for powder catalysts. Furthermore, a decrease in the OER overpotential is observed following surface aging in electrolyte for three days. At higher Ni load, AFM shows the growth of a new phase attributed to an (oxy)-hydroxide phase which, according to CV measurements, does not seem to correlate with the surface activity towards OER. EIS suggests that the OER precursor species observed on the clean and Ni-modified surfaces are similar and Fe-centered, but form at lower overpotentials when the surface Fe:Ni ratio is optimized.
△ Less
Submitted 27 September, 2021;
originally announced September 2021.
-
Electric-Double-Layer-Modulation Microscopy
Authors:
Kevin Namink,
Xuanhui Meng,
Marc T. M. Koper,
Philipp Kukura,
Sanli Faez
Abstract:
The electric double layer (EDL) formed around charged nanostructures at the liquid-solid interface determines their electrochemical activity and influences their electrical and optical polarizability. We experimentally demonstrate that restructuring of the EDL at the nanoscale can be detected by dark-field scattering microscopy. Temporal and spatial characterization of the scattering signal demons…
▽ More
The electric double layer (EDL) formed around charged nanostructures at the liquid-solid interface determines their electrochemical activity and influences their electrical and optical polarizability. We experimentally demonstrate that restructuring of the EDL at the nanoscale can be detected by dark-field scattering microscopy. Temporal and spatial characterization of the scattering signal demonstrates that the potentiodynamic optical contrast is proportional to the accumulated charge of polarisable ions at the interface and its time derivative represents the nanoscale ionic current. The material-specificity of the EDL formation is used in our work as a label-free contrast mechanism to image nanostructures and perform spatially-resolved cyclic voltametry on ion current density of a few attoamperes, corresponding to the exchange of only a few hundred ions.
△ Less
Submitted 9 April, 2020; v1 submitted 27 September, 2019;
originally announced September 2019.
-
Electrochemical Capacitance of CO-terminated Pt(111) is Dominated by CO-Solvent Gap
Authors:
Ravishankar Sundararaman,
Marta C. Figueiredo,
Marc T. M. Koper,
Kathleen A. Schwarz
Abstract:
The distribution of electric fields within the electrochemical double layer depends on both the electrode and electrolyte in complex ways. These fields strongly influence chemical dynamics in the electrode-electrolyte interface, but cannot be measured directly with sub-molecular resolution. We report experimental capacitance measurements for aqueous interfaces of CO-terminated Pt(111). By comparin…
▽ More
The distribution of electric fields within the electrochemical double layer depends on both the electrode and electrolyte in complex ways. These fields strongly influence chemical dynamics in the electrode-electrolyte interface, but cannot be measured directly with sub-molecular resolution. We report experimental capacitance measurements for aqueous interfaces of CO-terminated Pt(111). By comparing these measurements with first-principles density-functional theory (DFT) calculations, we infer microscopic field distributions and decompose contributions to the inverse capacitance from various spatial regions of the interface. We find that the CO is strongly electronically coupled to the Pt, and that most of the interfacial potential difference appears across the gap between the terminating O and water, and not across the CO molecule as previously hypothesized. This `gap capacitance' resulting from hydrophobic termination lowers the overall capacitance of the aqueous Pt-CO interface, and makes it less sensitive to electrolyte concentration compared to the bare metal.
△ Less
Submitted 18 October, 2017; v1 submitted 26 September, 2017;
originally announced September 2017.
-
An Off-lattice Model for Br Electrodeposition on Au(100): from DFT to Experiment
Authors:
S. J. Mitchell,
M. T. M. Koper
Abstract:
Since Br adsorption on Au(100) displays an incommensurate ordered phase, a lattice-gas treatment of the adlayer configurations is not reliable. We therefore use density functional theory slab calculations to determine the parameters necessary for the construction of an off-lattice model. We compute and analyze the total energy and electron density as the lateral Br position and coverage are vari…
▽ More
Since Br adsorption on Au(100) displays an incommensurate ordered phase, a lattice-gas treatment of the adlayer configurations is not reliable. We therefore use density functional theory slab calculations to determine the parameters necessary for the construction of an off-lattice model. We compute and analyze the total energy and electron density as the lateral Br position and coverage are varied. This allows the calculation of the corrugation potential, the short-range lateral interactions, the dipole moment (long-range interactions), and the residence charge. From these parameters, we construct an off-lattice model with no freely adjustable parameters. The simulation results compare remarkably well with experimental results.
△ Less
Submitted 4 February, 2004;
originally announced February 2004.
