-
Quasi-free (p,2p) reactions in inverse kinematics for studying the fission yield dependence on temperature
Authors:
A. Graña-González,
J. L. Rodríguez-Sánchez,
J. Benlliure,
G. García-Jiménez,
H. Alvarez-Pol,
D. Cortina-Gil,
L. Atar,
L. Audouin,
G. Authelet,
A. Besteiro,
G. Blanchon,
K. Boretzky,
P. Cabanelas,
E. Casarejos,
J. Cederkall,
A. Chatillon,
A. Corsi,
M. Feijoo,
D. Galaviz,
I. Gasparic,
R. Gernhäuser,
M. Heil,
A. Heinz,
M. Holl,
T. Jenegger
, et al. (37 additional authors not shown)
Abstract:
Despite the recent experimental and theoretical progress in the investigation of the nuclear fission process, a complete description still represents a challenge in nuclear physics because it is a very complex dynamical process, whose description involves the coupling between intrinsic and collective degrees of freedom, as well as different quantum-mechanical phenomena. To improve on the existing…
▽ More
Despite the recent experimental and theoretical progress in the investigation of the nuclear fission process, a complete description still represents a challenge in nuclear physics because it is a very complex dynamical process, whose description involves the coupling between intrinsic and collective degrees of freedom, as well as different quantum-mechanical phenomena. To improve on the existing data on nuclear fission, we produce fission reactions of heavy nuclei in inverse kinematics by using quasi-free (p,2p) scattering, which induce fission through particle-hole excitations that can range from few to ten's of MeV. The measurement of the four-momenta of the two outgoing protons allows to reconstruct the excitation energy of the fissioning compound nucleus and therefore to study the evolution of the fission yields with temperature. The realization of this kind of experiment requires a complex experimental setup, providing full isotopic identification of both fission fragments and an accurate measurement of the momenta of the two outgoing protons. This was realized recently at the GSI/FAIR facility and here some preliminary results are presented.
△ Less
Submitted 12 October, 2022;
originally announced October 2022.
-
Comprehensive investigation of fission yields by using spallation- and (p,2p)-induced fission reactions in inverse kinematics
Authors:
J. L. Rodríguez-Sánchez,
A. Graña-González,
J. Benlliure,
A. Chatillon,
G. García-Jiménez,
J. Taieb,
H. Alvarez-Pol,
L. Atar,
L. Audouin,
G. Authelet,
A. Besteiro,
G. Blanchon,
K. Boretzky,
P. Cabanelas,
E. Casarejos,
J. Cederkall,
D. Cortina-Gil,
A. Corsi,
E. De Filippo,
M. Feijoo,
D. Galaviz,
I. Gasparic,
R. Gernhäuser,
E. Haettner,
M. Heil
, et al. (44 additional authors not shown)
Abstract:
In the last decades, measurements of spallation, fragmentation and Coulex induced fission reactions in inverse kinematics have provided valuable data to accurately investigate the fission dynamics and nuclear structure at large deformations of a large variety of stable and non-stable heavy nuclei. To go a step further, we propose now to induce fission by the use of quasi-free (p,2p) scattering rea…
▽ More
In the last decades, measurements of spallation, fragmentation and Coulex induced fission reactions in inverse kinematics have provided valuable data to accurately investigate the fission dynamics and nuclear structure at large deformations of a large variety of stable and non-stable heavy nuclei. To go a step further, we propose now to induce fission by the use of quasi-free (p,2p) scattering reactions in inverse kinematics, which allows us to reconstruct the excitation energy of the compound fissioning system by using the four-momenta of the two outgoing protons. Therefore, this new approach might permit to correlate the excitation energy with the charge and mass distributions of the fission fragments and with the fission probabilities, given for the first time direct access to the simultaneous measurement of the fission yield dependence on temperature and fission barrier heights of exotic heavy nuclei, respectively. The first experiment based on this methodology was realized recently at the GSI/FAIR facility and a detailed description of the experimental setup is given here.
△ Less
Submitted 10 October, 2022;
originally announced October 2022.
-
Fakernet -- small and fast FPGA-based TCP and UDP communication
Authors:
H. T. Johansson,
A. Furufors,
P. Klenze
Abstract:
A common theme of data acquisition systems is the transport of data from digitising front-end modules to stable storage and online analysis. A good choice today is to base this on the ubiquitous, commercially and cheaply available Ethernet technology. A firmware building block to turn already the FPGA of front-end electronics into a TCP data source and UDP control interface using a data-flow archi…
▽ More
A common theme of data acquisition systems is the transport of data from digitising front-end modules to stable storage and online analysis. A good choice today is to base this on the ubiquitous, commercially and cheaply available Ethernet technology. A firmware building block to turn already the FPGA of front-end electronics into a TCP data source and UDP control interface using a data-flow architecture is presented. The overall performance targets are to be able to saturate a 1 Gbps network link with outbound data, while using few FPGA resources. The goal is to replace the use of custom data buses and protocols with ordinary Ethernet equipment. These objectives are achieved by being just-enough conforming, such that no special drivers are needed in the PC equipment interfacing with the here presented Fakernet system. An important design choice is to handle all packet-data internally as 16-bit words, thus reducing the clock-speed requirements. An advantageous circumstance is that even at 1 Gbps speeds, for local network segments, the round-trip times are usually well below 500 microseconds. Thus, less than 50 kiB of unacknowledged data needs to be in-flight, allowing to saturate a network link without TCP window scaling. The Fakernet system has so far been shown to saturate a 100 Mbps link at 11.7 MB/s of TCP output data, and able to do 32-bit control register accesses at over 450 kword/s.
△ Less
Submitted 27 March, 2020;
originally announced March 2020.
-
Commissioning of the CALIFA Barrel Calorimeter of the R$^{3}$B Experiment at FAIR
Authors:
P Cabanelas,
H Alvarez-Pol,
J M Boillos,
E Casarejos,
J Cederkall,
D Cortina,
M Feijoo,
D Galaviz,
E Galiana R Gernhäuser,
P Golubev,
D González,
A-L Hartig,
A Heinz,
H Johansson,
P Klenze,
A Knyazev,
T Kröll,
E Nacher,
J Park,
A Perea,
L Ponnath,
H-B Rhee,
J L Rodríguez-Sánchez,
C Suerder,
O Tengblad
, et al. (1 additional authors not shown)
Abstract:
CALIFA is the high efficiency and energy resolution calorimeter for the R$^{3}$B experiment at FAIR, intended for detecting high energy charged particles and $γ$-rays in inverse kinematics direct reactions. It surrounds the reaction target in a segmented configuration of Barrel and Forward End-Cap pieces. The CALIFA Barrel consists of 1952 detection units made of CsI(Tl) long-shaped scintillator c…
▽ More
CALIFA is the high efficiency and energy resolution calorimeter for the R$^{3}$B experiment at FAIR, intended for detecting high energy charged particles and $γ$-rays in inverse kinematics direct reactions. It surrounds the reaction target in a segmented configuration of Barrel and Forward End-Cap pieces. The CALIFA Barrel consists of 1952 detection units made of CsI(Tl) long-shaped scintillator crystals, and it is being commissioned during the Phase0 experiments at FAIR. The first setup for the CALIFA Barrel commissioning is presented here. Results of detector performance with $γ$-rays are obtained, and show that the system fulfills the design requirements.
△ Less
Submitted 6 March, 2020;
originally announced March 2020.
-
Performance recovery of long CsI(Tl) scintillator crystals with APD-based readout
Authors:
P. Cabanelas,
D. González,
H. Alvarez-Pol,
J. M. Boillos,
E. Casarejos,
J. Cederkall,
D. Cortina,
M. Feijoo,
D. Galaviz,
E. Galiana,
R. Gernhäuser,
P. Golubev,
A. -L. Hartig,
P. Klenze,
A. Knyazev,
T. Kröll,
E. Nácher,
J. Park,
A. Perea,
B. Pietras,
L. Ponnath,
H. -B. Rhee,
J. L. Rodríguez-Sánchez,
C. Suerder,
O. Tengblad
, et al. (1 additional authors not shown)
Abstract:
CALIFA is the high efficiency and energy resolution calorimeter for the R3B experiment at FAIR, intended for detecting high energy light charged particles and gamma rays in scattering experiments, and is being commissioned during the Phase-0 experiments at FAIR, between 2018 and 2020. It surrounds the reaction target in a segmented configuration with 2432 detection units made of long CsI(Tl) finge…
▽ More
CALIFA is the high efficiency and energy resolution calorimeter for the R3B experiment at FAIR, intended for detecting high energy light charged particles and gamma rays in scattering experiments, and is being commissioned during the Phase-0 experiments at FAIR, between 2018 and 2020. It surrounds the reaction target in a segmented configuration with 2432 detection units made of long CsI(Tl) finger-shaped scintillator crystals. CALIFA has a 10 year intended operational lifetime as the R3B calorimeter, necessitating measures to be taken to ensure enduring performance. In this paper we present a systematic study of two groups of 6 different detection units of the CALIFA detector after more than four years of operation. The energy resolution and light output yield are evaluated under different conditions. Tests cover the aging of the first detector units assembled and investigates recovery procedures for degraded detection units. A possible reason for the observed degradation is given, pointing to the crystal-APD coupling.
△ Less
Submitted 27 March, 2020; v1 submitted 3 March, 2020;
originally announced March 2020.
