-
How Tiny Can Analog Filterbank Features Be Made for Ultra-low-power On-device Keyword Spotting?
Authors:
Subhajit Ray,
Xinghua Sun,
Nolan Tremelling,
Maria Gordiyenko,
Peter Kinget
Abstract:
Analog feature extraction is a power-efficient and re-emerging signal processing paradigm for implementing the front-end feature extractor in on device keyword-spotting systems. Despite its power efficiency and re-emergence, there is little consensus on what values the architectural parameters of its critical block, the analog filterbank, should be set to, even though they strongly influence power…
▽ More
Analog feature extraction is a power-efficient and re-emerging signal processing paradigm for implementing the front-end feature extractor in on device keyword-spotting systems. Despite its power efficiency and re-emergence, there is little consensus on what values the architectural parameters of its critical block, the analog filterbank, should be set to, even though they strongly influence power consumption. Towards building consensus and approaching fundamental power consumption limits, we find via simulation that through careful selection of its architectural parameters, the power of a typical state-of-the-art analog filterbank could be reduced by 33.6x, while sacrificing only 1.8% in downstream 10-word keyword spotting accuracy through a back-end neural network.
△ Less
Submitted 17 April, 2023;
originally announced April 2023.
-
The Phase-I Trigger Readout Electronics Upgrade of the ATLAS Liquid Argon Calorimeters
Authors:
G. Aad,
A. V. Akimov,
K. Al Khoury,
M. Aleksa,
T. Andeen,
C. Anelli,
N. Aranzabal,
C. Armijo,
A. Bagulia,
J. Ban,
T. Barillari,
F. Bellachia,
M. Benoit,
F. Bernon,
A. Berthold,
H. Bervas,
D. Besin,
A. Betti,
Y. Bianga,
M. Biaut,
D. Boline,
J. Boudreau,
T. Bouedo,
N. Braam,
M. Cano Bret
, et al. (173 additional authors not shown)
Abstract:
The Phase-I trigger readout electronics upgrade of the ATLAS Liquid Argon calorimeters enhances the physics reach of the experiment during the upcoming operation at increasing Large Hadron Collider luminosities. The new system, installed during the second Large Hadron Collider Long Shutdown, increases the trigger readout granularity by up to a factor of ten as well as its precision and range. Cons…
▽ More
The Phase-I trigger readout electronics upgrade of the ATLAS Liquid Argon calorimeters enhances the physics reach of the experiment during the upcoming operation at increasing Large Hadron Collider luminosities. The new system, installed during the second Large Hadron Collider Long Shutdown, increases the trigger readout granularity by up to a factor of ten as well as its precision and range. Consequently, the background rejection at trigger level is improved through enhanced filtering algorithms utilizing the additional information for topological discrimination of electromagnetic and hadronic shower shapes. This paper presents the final designs of the new electronic elements, their custom electronic devices, the procedures used to validate their proper functioning, and the performance achieved during the commissioning of this system.
△ Less
Submitted 16 May, 2022; v1 submitted 15 February, 2022;
originally announced February 2022.
-
Performance and Quality Control of a Radiation-Hard 12-bit 40 MSPS ADC for the ATLAS Liquid Argon Calorimeter Trigger Readout Electronics Phase-I Upgrade at the LHC
Authors:
T. Andeen,
J. Ban,
G. Brooijmans,
A. Emerman,
P. Kinget,
J. Kuppambatti,
D. Mahon,
I. Ochoa,
W. Sippach,
Q. Wang
Abstract:
A radiation-hard quad-channel 12-bit 40 MSPS pipeline analog-to-digital converter (ADC) has been designed for the trigger readout electronics Phase-I upgrade of the ATLAS Liquid Argon calorimeter, at the CERN Large Hadron Collider. The final version of the custom design, fabricated in a commercial 130 nm CMOS process, is presented and found to meet the system requirements for analog performance an…
▽ More
A radiation-hard quad-channel 12-bit 40 MSPS pipeline analog-to-digital converter (ADC) has been designed for the trigger readout electronics Phase-I upgrade of the ATLAS Liquid Argon calorimeter, at the CERN Large Hadron Collider. The final version of the custom design, fabricated in a commercial 130 nm CMOS process, is presented and found to meet the system requirements for analog performance and radiation tolerance. The procedure for quality control of 17200 ADCs is described and the results are presented.
△ Less
Submitted 6 March, 2020; v1 submitted 12 December, 2019;
originally announced December 2019.
-
FPGA with Improved Routability and Robustness in 130nm CMOS with Open-Source CAD Targetability
Authors:
Guanshun Yu,
Tom Y. Cheng,
Blayne Kettlewell,
Harrison Liew,
Mingoo Seok,
Peter R. Kinget
Abstract:
This paper outlines an FPGA VLSI design methodology that was used to realize a fully functioning FPGA chip in 130nm CMOS with improved routability and memory robustness. The architectural design space exploration and synthesis capability were enabled by the Verilog-to-Routing CAD tool. The capabilities of this tool were extended to enable bitstream generation and deployment. To validate the archit…
▽ More
This paper outlines an FPGA VLSI design methodology that was used to realize a fully functioning FPGA chip in 130nm CMOS with improved routability and memory robustness. The architectural design space exploration and synthesis capability were enabled by the Verilog-to-Routing CAD tool. The capabilities of this tool were extended to enable bitstream generation and deployment. To validate the architecture and bitstream implementation, a Chisel (Constructing Hardware in the Embedded Scala Language) model of the FPGA was created to rapidly verify the microarchitectural details of the device prior to schematic design. A custom carrier board and configuration tool were used to verify correct operational characteristics of the FPGA over various resource utilizations and clock frequencies.
△ Less
Submitted 9 December, 2017;
originally announced December 2017.
-
A radiation-hard dual-channel 12-bit 40 MS/s ADC prototype for the ATLAS liquid argon calorimeter readout electronics upgrade at the CERN LHC
Authors:
Jayanth Kuppambatti,
Jaroslav Ban,
Timothy Andeen,
Rex Brown,
Ryne Carbone,
Peter Kinget,
Gustaaf Brooilmans,
William Sippach
Abstract:
The readout electronics upgrade for the ATLAS Liquid Argon Calorimeters at the CERN Large Hadron Collider requires a radiation-hard ADC. The design of a radiation-hard dual-channel 12-bit 40 MS/s pipeline ADC for this use is presented. The design consists of two pipeline A/D channels each with four Multiplying Digital-to-Analog Converters followed by 8-bit Successive-Approximation-Register analog-…
▽ More
The readout electronics upgrade for the ATLAS Liquid Argon Calorimeters at the CERN Large Hadron Collider requires a radiation-hard ADC. The design of a radiation-hard dual-channel 12-bit 40 MS/s pipeline ADC for this use is presented. The design consists of two pipeline A/D channels each with four Multiplying Digital-to-Analog Converters followed by 8-bit Successive-Approximation-Register analog-to-digital converters. The custom design, fabricated in a commercial 130 nm CMOS process, shows a performance of 67.9 dB SNDR at 10 MHz for a single channel at 40 MS/s, with a latency of 87.5 ns (to first bit read out), while its total power consumption is 50 mW/channel. The chip uses two power supply voltages: 1.2 and 2.5 V. The sensitivity to single event effects during irradiation is measured and determined to meet the system requirements.
△ Less
Submitted 5 June, 2017;
originally announced June 2017.
-
Project-based Learning within a Large-Scale Interdisciplinary Research Effort
Authors:
Robert Margolies,
Maria Gorlatova,
John Sarik,
Peter Kinget,
Ioannis Kymissis,
Gil Zussman
Abstract:
The modern engineering landscape increasingly requires a range of skills to successfully integrate complex systems. Project-based learning is used to help students build professional skills. However, it is typically applied to small teams and small efforts. This paper describes an experience in engaging a large number of students in research projects within a multi-year interdisciplinary research…
▽ More
The modern engineering landscape increasingly requires a range of skills to successfully integrate complex systems. Project-based learning is used to help students build professional skills. However, it is typically applied to small teams and small efforts. This paper describes an experience in engaging a large number of students in research projects within a multi-year interdisciplinary research effort. The projects expose the students to various disciplines in Computer Science (embedded systems, algorithm design, networking), Electrical Engineering (circuit design, wireless communications, hardware prototy**), and Applied Physics (thin-film battery design, solar cell fabrication). While a student project is usually focused on one discipline area, it requires interaction with at least two other areas. Over 5 years, 180 semester-long projects have been completed. The students were a diverse group of high school, undergraduate, and M.S. Computer Science, Computer Engineering, and Electrical Engineering students. Some of the approaches that were taken to facilitate student learning are real-world system development constraints, regular cross-group meetings, and extensive involvement of Ph.D. students in student mentorship and knowledge transfer. To assess the approaches, a survey was conducted among the participating students. The results demonstrate the effectiveness of the approaches. For example, 70% of the students surveyed indicated that working on their research project improved their ability to function on multidisciplinary teams more than coursework, internships, or any other activity.
△ Less
Submitted 25 October, 2014;
originally announced October 2014.
-
A Radiation-Hard Dual Channel 4-bit Pipeline for a 12-bit 40 MS/s ADC Prototype with extended Dynamic Range for the ATLAS Liquid Argon Calorimeter Readout Electronics Upgrade at the CERN LHC
Authors:
Jayanth Kuppambatti,
Jaroslav Ban,
Timothy Andeen,
Peter Kinget,
Gustaaf Brooijmans
Abstract:
The design of a radiation-hard dual channel 12-bit 40 MS/s pipeline ADC with extended dynamic range is presented, for use in the readout electronics upgrade for the ATLAS Liquid Argon Calorimeters at the CERN Large Hadron Collider. The design consists of two pipeline A/D channels with four Multiplying Digital-to-Analog Converters with nominal 12-bit resolution each. The design, fabricated in the I…
▽ More
The design of a radiation-hard dual channel 12-bit 40 MS/s pipeline ADC with extended dynamic range is presented, for use in the readout electronics upgrade for the ATLAS Liquid Argon Calorimeters at the CERN Large Hadron Collider. The design consists of two pipeline A/D channels with four Multiplying Digital-to-Analog Converters with nominal 12-bit resolution each. The design, fabricated in the IBM 130 nm CMOS process, shows a performance of 68 dB SNDR at 18 MHz for a single channel at 40 MS/s while consuming 55 mW/channel from a 2.5 V supply, and exhibits no performance degradation after irradiation. Various gain selection algorithms to achieve the extended dynamic range are implemented and tested.
△ Less
Submitted 31 July, 2013;
originally announced August 2013.