-
Anatomical MRI with an atomic magnetometer
Authors:
I. Savukov,
T. Karaulanov
Abstract:
Ultra-low field (ULF) MRI is a promising method for inexpensive medical imaging with various additional advantages over conventional instruments such as low weight, low power, portability, absence of artifacts from metals, and high contrast. Anatomical ULF MRI has been successfully implemented with SQUIDs, but SQUIDs have the drawback of cryogen requirement. Atomic magnetometers have sensitivity c…
▽ More
Ultra-low field (ULF) MRI is a promising method for inexpensive medical imaging with various additional advantages over conventional instruments such as low weight, low power, portability, absence of artifacts from metals, and high contrast. Anatomical ULF MRI has been successfully implemented with SQUIDs, but SQUIDs have the drawback of cryogen requirement. Atomic magnetometers have sensitivity comparable to SQUIDs and can be in principle used for ULF MRI to replace SQUIDs. Unfortunately some problems exist due to the sensitivity of atomic magnetometers to magnetic field and gradients. At low frequency, noise is also substantial and a shielded room is needed for improving sensitivity. In this paper, we show that at 85 kHz, the atomic magnetometer can be used to obtain anatomical images. This is the first demonstration of any use of atomic magnetometers for anatomical MRI. The demonstrated resolution is 1.1x1.4 mm2 in about six minutes of acquisition with SNR of 10. Some applications of the method are discussed. With several measures it is also possible to increase sensitivity to reach resolution 1x1 mm2, which is typical in medical imaging.
△ Less
Submitted 20 December, 2012;
originally announced December 2012.
-
Pressure broadening and shift of D1 line of Ag by He, Ar and N2
Authors:
T. Karaulanov,
B. K. Park,
D. Budker,
A. O. Sushkov
Abstract:
We have studied experimentally pressure broadening and shift of Ag D1 line caused by He, Ar and N2 buffer gases. The measurements were done in a heat-pipe type absorption cell at a temperature of ~1000 K and gas pressures up to 1000 torr. The measured values for pressure broadening and shift (in MHz/Torr) are as follows: Ag-He 5.8(1), +1.16(2); Ag-Ar 5.2(2), -2.28(4); Ag-N2 5.2(1), -2.52(7). The "…
▽ More
We have studied experimentally pressure broadening and shift of Ag D1 line caused by He, Ar and N2 buffer gases. The measurements were done in a heat-pipe type absorption cell at a temperature of ~1000 K and gas pressures up to 1000 torr. The measured values for pressure broadening and shift (in MHz/Torr) are as follows: Ag-He 5.8(1), +1.16(2); Ag-Ar 5.2(2), -2.28(4); Ag-N2 5.2(1), -2.52(7). The "+" and "-" signs indicate the direction for the shifts to the blue and red side of the spectrum, respectively.
△ Less
Submitted 17 January, 2012;
originally announced January 2012.
-
Polarized alkali vapor with minute-long transverse spin-relaxation time
Authors:
Misha Balabas,
Todor Karaulanov,
Micah Ledbetter,
Dmitry Budker
Abstract:
We demonstrate lifetimes of atomic populations and coherences in excess of 60 seconds in alkali vapor cells with inner walls coated with an alkene material. This represents two orders of magnitude improvement over the best paraffin coatings. Such anti-relaxation properties will likely lead to substantial improvements in atomic clocks, magnetometers, quantum memory, and enable sensitive studies of…
▽ More
We demonstrate lifetimes of atomic populations and coherences in excess of 60 seconds in alkali vapor cells with inner walls coated with an alkene material. This represents two orders of magnitude improvement over the best paraffin coatings. Such anti-relaxation properties will likely lead to substantial improvements in atomic clocks, magnetometers, quantum memory, and enable sensitive studies of collisional effects and precision measurements of fundamental symmetries.
△ Less
Submitted 10 May, 2010;
originally announced May 2010.
-
Rubidium dimers in paraffin-coated cells
Authors:
V. M. Acosta,
A. Jarmola,
D. Windes,
E. Corsini,
M. P. Ledbetter,
T. Karaulanov,
M. Auzinsh,
S. A. Rangwala,
D. F. Jackson Kimball,
D. Budker
Abstract:
Measurements were made to determine the density of rubidium dimer vapor in paraffin-coated cells. The number density of dimers and atoms in similar paraffin-coated and uncoated cells was measured by optical spectroscopy. Due to the relatively low melting point of paraffin, a limited temperature range of 43-80 deg C was explored, with the lower end corresponding to a dimer density of less than 10^7…
▽ More
Measurements were made to determine the density of rubidium dimer vapor in paraffin-coated cells. The number density of dimers and atoms in similar paraffin-coated and uncoated cells was measured by optical spectroscopy. Due to the relatively low melting point of paraffin, a limited temperature range of 43-80 deg C was explored, with the lower end corresponding to a dimer density of less than 10^7 cm^(-3). With one-minute integration time, a sensitivity to dimer number density of better than 10^6 cm^(-3) was achieved. No significant difference in dimer density was observed between the cells.
△ Less
Submitted 29 July, 2010; v1 submitted 3 May, 2010;
originally announced May 2010.
-
Investigation of Anti-Relaxation Coatings for Alkali-Metal Vapor Cells Using Surface Science Techniques
Authors:
S. J. Seltzer,
D. J. Michalak,
M. H. Donaldson,
M. V. Balabas,
S. K. Barber,
S. L. Bernasek,
M. -A. Bouchiat,
A. Hexemer,
A. M. Hibberd,
D. F. Jackson Kimball,
C. Jaye,
T. Karaulanov,
F. A. Narducci,
S. A. Rangwala,
H. G. Robinson,
A. K. Shmakov,
D. L. Voronov,
V. V. Yashchuk,
A. Pines,
D. Budker
Abstract:
Many technologies based on cells containing alkali-metal atomic vapor benefit from the use of anti-relaxation surface coatings in order to preserve atomic spin polarization. In particular, paraffin has been used for this purpose for several decades and has been demonstrated to allow an atom to experience up to 10,000 collisions with the walls of its container without depolarizing, but the details…
▽ More
Many technologies based on cells containing alkali-metal atomic vapor benefit from the use of anti-relaxation surface coatings in order to preserve atomic spin polarization. In particular, paraffin has been used for this purpose for several decades and has been demonstrated to allow an atom to experience up to 10,000 collisions with the walls of its container without depolarizing, but the details of its operation remain poorly understood. We apply modern surface and bulk techniques to the study of paraffin coatings, in order to characterize the properties that enable the effective preservation of alkali spin polarization. These methods include Fourier transform infrared spectroscopy, differential scanning calorimetry, atomic force microscopy, near-edge X-ray absorption fine structure spectroscopy, and X-ray photoelectron spectroscopy. We also compare the light-induced atomic desorption yields of several different paraffin materials. Experimental results include the determination that crystallinity of the coating material is unnecessary, and the detection of C=C double bonds present within a particular class of effective paraffin coatings. Further study should lead to the development of more robust paraffin anti-relaxation coatings, as well as the design and synthesis of new classes of coating materials.
△ Less
Submitted 11 October, 2010; v1 submitted 23 February, 2010;
originally announced February 2010.
-
Controlling atomic vapor density in paraffin-coated cells using light-induced atomic desorption
Authors:
T. Karaulanov,
M. T. Graf,
D. English,
S. M. Rochester,
Y. Rosen,
K. Tsigutkin,
D. Budker,
E. B. Alexandrov,
M. V. Balabas,
D. F. Jackson Kimball,
F. A. Narducci,
S. Pustelny,
V. V. Yashchuk
Abstract:
Atomic-vapor density change due to light induced atomic desorption (LIAD) is studied in paraffin-coated rubidium, cesium, sodium and potassium cells. In the present experiment, low-intensity probe light is used to obtain an absorption spectrum and measure the vapor density, while light from an argon-ion laser, array of light emitting diodes, or discharge lamp is used for desorption. Potassium is…
▽ More
Atomic-vapor density change due to light induced atomic desorption (LIAD) is studied in paraffin-coated rubidium, cesium, sodium and potassium cells. In the present experiment, low-intensity probe light is used to obtain an absorption spectrum and measure the vapor density, while light from an argon-ion laser, array of light emitting diodes, or discharge lamp is used for desorption. Potassium is found to exhibit significantly weaker LIAD from paraffin compared to Rb and Cs, and we were unable to observe LIAD with sodium. A simple LIAD model is applied to describe the observed vapor-density dynamics, and the role of the cell's stem is explored through the use of cells with lockable stems. Stabilization of Cs vapor density above its equilibrium value over 25 minutes is demonstrated. The results of this work could be used to assess the use of LIAD for vapor-density control in magnetometers, clocks, and gyroscopes utilizing coated cells.
△ Less
Submitted 23 October, 2008; v1 submitted 3 June, 2008;
originally announced June 2008.
-
Efficient collinear third-harmonic generation in a single two-dimensional nonlinear photonic crystal
Authors:
Todor Karaulanov,
Solomon M. Saltiel
Abstract:
We propose novel multi-phase-matched process that starts with generation of a pair of symmetric second-harmonic waves. Each of them interacts again with the fundamental wave to produce two constructively interfering third harmonic waves collinear to the fundamental input wave.
We propose novel multi-phase-matched process that starts with generation of a pair of symmetric second-harmonic waves. Each of them interacts again with the fundamental wave to produce two constructively interfering third harmonic waves collinear to the fundamental input wave.
△ Less
Submitted 3 September, 2003;
originally announced September 2003.
