Showing 1–4 of 4 results for author: Harrer, G

Probing non-linear MHD stability of the EDA H-mode in ASDEX Upgrade

Authors: A Cathey, M Hoelzl, L Gil, MG Dunne, GF Harrer, GTA Huijsmans, J Kalis, K Lackner, SJP Pamela, E Wolfrum, S Günter, the JOREK team, the ASDEX Upgrade Team, the EUROfusion MST1 Team

Abstract: Regimes of operation in tokamaks that are devoid of large ELMs have to be better understood to extrapolate their applicability to reactor-relevant devices. This paper describes non-linear extended MHD simulations that use an experimental equilibrium from an EDA H-mode in ASDEX Upgrade. Linear ideal MHD analysis indicates that the operational point lies slightly inside of the stable region. The non… ▽ More Regimes of operation in tokamaks that are devoid of large ELMs have to be better understood to extrapolate their applicability to reactor-relevant devices. This paper describes non-linear extended MHD simulations that use an experimental equilibrium from an EDA H-mode in ASDEX Upgrade. Linear ideal MHD analysis indicates that the operational point lies slightly inside of the stable region. The non-linear simulations with the visco-resistive extended MHD code, JOREK, sustain non-axisymmetric perturbations that are linearly most unstable with toroidal mode numbers of n = \{6 \dots 9\}, but non-linearly higher and lower n become driven and the low-n become dominant. The poloidal mode velocity during the linear phase is found to correspond to the expected velocity for resistive ballooning modes. The perturbations that exist in the simulations have somewhat smaller poloidal wavenumbers (k_θ \sim 0.1 to 0.5 cm^{-1} ) than the experimental expectations for the quasi-coherent mode in EDA, and cause non-negligible transport in both the heat and particle channels. In the transition from linear to non-linear phase, the mode frequency chirps down from approximately 35 kHz to 13 kHz, which corresponds approximately to the lower end of frequencies that are typically observed in EDA H-modes in ASDEX Upgrade. △ Less

Submitted 22 January, 2023; originally announced January 2023.

A quasi-continuous exhaust scenario for a fusion reactor: the renaissance of small edge localized modes

Authors: G. F. Harrer, M. Faitsch, L. Radovanovic, E. Wolfrum, C. Albert, A. Cathey, M. Cavedon, M. Dunne, T. Eich, R. Fischer, M. Hoelzl, B. Labit, H. Meyer, F. Aumayr, the ASDEX Upgrade Team, the EUROfusion MST1 Team

Abstract: Tokamak operational regimes with small edge localized modes (ELMs) could be a solution to the problem of large transient heat loads in future fusion reactors because they provide quasi-continuous exhaust while kee** a good plasma confinement. A ballooning mode mechanism near the last closed flux surface (LCFS) governed by an interplay of the pressure gradient and the magnetic shear there has bee… ▽ More Tokamak operational regimes with small edge localized modes (ELMs) could be a solution to the problem of large transient heat loads in future fusion reactors because they provide quasi-continuous exhaust while kee** a good plasma confinement. A ballooning mode mechanism near the last closed flux surface (LCFS) governed by an interplay of the pressure gradient and the magnetic shear there has been proposed for small ELMs in high density ASDEX Upgrade and TCV discharges. In this manuscript we explore different factors relevant for plasma edge stability in a wide range of edge safety factors by changing the connection length between the good and the bad curvature side. Simultaneously this influences the stabilizing effect of the local magnetic shear close to the LCFS as well as the $E \times B$ flow shear. Ideal ballooning stability calculations with the HELENA code reveal that small ELM plasmas are indeed unstable against ballooning modes very close to the LCFS but can exhibit second ballooning stability in the steep gradient region which correlates with enhanced confinement. We also present first non-linear simulations of small ELM regimes with the JOREK code including the $E \times B$ shear which indeed develop ballooning like fluctuations in the high triangularity limit. In the region where the small ELMs originate the dimensionless parameters are very similar in our investigated discharges and in a reactor, making this regime the ideal exhaust scenario for a future reactor. △ Less

Submitted 25 October, 2021; originally announced October 2021.

MHD simulations of small ELMs at low triangularity in ASDEX Upgrade

Authors: A. Cathey, M. Hoelzl, G. Harrer, M. G. Dunne, G. T. A. Huijsmans, K. Lackner, S. J. P. Pamela, E. Wolfrum, S. Günter, the JOREK team, the ASDEX Upgrade Team, the EUROfusion MST1 Team

Abstract: The development of small- and no-ELM regimes for ITER is a high priority topic due to the risks associated to type-I ELMs. By considering non-linear extended MHD simulations of the ASDEX Upgrade tokamak with the JOREK code, we probe a regime that avoids type-I ELMs completely provided that the separatrix density is high enough. The dynamics of the pedestal in this regime are observed to be qualita… ▽ More The development of small- and no-ELM regimes for ITER is a high priority topic due to the risks associated to type-I ELMs. By considering non-linear extended MHD simulations of the ASDEX Upgrade tokamak with the JOREK code, we probe a regime that avoids type-I ELMs completely provided that the separatrix density is high enough. The dynamics of the pedestal in this regime are observed to be qualitatively similar to the so-called quasi-continuous exhaust (QCE) regime in several ways. Repetitive type-I ELMs are substituted by roughly constant levels of outwards transport caused by peeling-ballooning modes (with dominant ballooning characteristics) which are localised in the last 5\% of the confined region (in normalised poloidal flux). The simulated low triangularity plasma transitions to a type-I ELMy H-mode if the separatrix density is sufficiently reduced or if the input heating power is sufficiently increased. The stabilising factors that play a role in the suppression of the small ELMs are also investigated by analysing the simulations, and the importance of including diamagnetic effects in the simulations is highlighted. By considering a scan in the pedestal resistivity and by measuring the poloidal velocity of the modes (and comparing to theoretical estimates for ideal and resistive modes), we identify the underlying instabilities as resistive peeling-ballooning modes. Decreasing the resistivity below experimentally-relevant conditions (i.e., going towards ideal MHD), the peeling-ballooning modes that constrain the pedestal below the type-I ELM stability boundary display sharply decreasing growth rates. △ Less

Submitted 15 October, 2021; originally announced October 2021.

I-mode pedestal relaxation events at ASDEX Upgrade

Authors: D. Silvagni, T. Eich, T. Happel, G. F. Harrer, M. Griener, M. Dunne, M. Cavedon, M. Faitsch, L. Gil, D. Nille, B. Tal, R. Fischer, U. Stroth, D. Brida, P. David, P. Manz, E. Viezzer, the ASDEX Upgrade team, the EUROfusion MST1 team

Abstract: The I-mode confinement regime can feature small edge temperature drops that can lead to an increase in the energy deposited onto the divertor targets. In this work, we show that these events are associated with a relaxation of both electron temperature and density edge profiles, with the largest drop found at the pedestal top position. Stability analysis of edge profiles reveals that the operation… ▽ More The I-mode confinement regime can feature small edge temperature drops that can lead to an increase in the energy deposited onto the divertor targets. In this work, we show that these events are associated with a relaxation of both electron temperature and density edge profiles, with the largest drop found at the pedestal top position. Stability analysis of edge profiles reveals that the operational points are far from the ideal peeling-ballooning boundary. Also, we show that these events appear close to the H-mode transition in the typical I-mode operational space in ASDEX Upgrade, and that no further enhancement of energy confinement is found when they occur. Moreover, scrape-off layer transport during these events is found to be very similar to type-I ELMs, with regard to timescales ($\approx$ 800 $μ$s), filament propagation, toroidally asymmetric energy effluxes at the midplane and asymmetry between inner and outer divertor deposited energy. In particular, the latter reveals that more energy reaches the outer divertor target. Lastly, first measurements of the divertor peak energy fluence are reported, and projections to ARC - a reactor designed to operate in I-mode - are drawn. △ Less

Submitted 19 June, 2020; originally announced June 2020.