Showing 1–6 of 6 results for author: Cohen, M A

Optomechanical microwave amplification without mechanical amplification

Authors: Martijn A. Cohen, Daniel Bothner, Yaroslav M. Blanter, Gary A. Steele

Abstract: High-gain and low-noise signal amplification is a valuable tool in various cryogenic microwave experiments. A microwave optomechanical device, in which a vibrating capacitor modulates the frequency of a microwave cavity, is one technique that is able to amplify microwave signals with high gain and large dynamical range. Such optomechanical amplifiers typically rely on strong backaction of microwav… ▽ More High-gain and low-noise signal amplification is a valuable tool in various cryogenic microwave experiments. A microwave optomechanical device, in which a vibrating capacitor modulates the frequency of a microwave cavity, is one technique that is able to amplify microwave signals with high gain and large dynamical range. Such optomechanical amplifiers typically rely on strong backaction of microwave photons on the mechanical mode achieved in the sideband-resolved limit of optomechanics. Here, we observe microwave amplification in an optomechanical cavity in the extremely unresolved sideband limit. A large gain is observed for any detuning of the single pump tone within the cavity linewidth, a clear indication that the amplification is not induced by dynamical backaction. By being able to amplify for any detuning of the pump signal, the amplification center frequency can be tuned over the entire range of the broad cavity linewidth. Additionally, by providing microwave amplification without mechanical amplification, we predict that using this scheme it is possible to achieve near-quantum-limited microwave amplification despite a large thermal occupation of the mechanical mode. △ Less

Submitted 22 January, 2020; v1 submitted 13 December, 2018; originally announced December 2018.

Journal ref: Phys. Rev. Applied 13, 014028 (2020)

A split-cavity design for the incorporation of a DC bias in a 3D microwave cavity

Authors: Martijn A. Cohen, Mingyun Yuan, Bas W. A. de Jong, Ewout Beukers, Sal J. Bosman, Gary A. Steele

Abstract: We report on a technique for applying a DC bias in a 3D microwave cavity. We achieve this by isolating the two halves of the cavity with a dielectric and directly using them as DC electrodes. As a proof of concept, we embed a variable capacitance diode in the cavity and tune the resonant frequency with a DC voltage, demonstrating the incorporation of a DC bias into the 3D cavity with no measurable… ▽ More We report on a technique for applying a DC bias in a 3D microwave cavity. We achieve this by isolating the two halves of the cavity with a dielectric and directly using them as DC electrodes. As a proof of concept, we embed a variable capacitance diode in the cavity and tune the resonant frequency with a DC voltage, demonstrating the incorporation of a DC bias into the 3D cavity with no measurable change in its quality factor at room temperature. We also characterize the architecture at millikelvin temperatures and show that the split cavity design maintains a quality factor $Q_\text{i} \sim 8.8 \times 10^5$, making it promising for future quantum applications. △ Less

Submitted 24 April, 2017; originally announced April 2017.

Silicon nitride membrane resonators at millikelvin temperatures with quality factors exceeding $10^8$

Authors: Mingyun Yuan, Martijn A. Cohen, Gary Steele

Abstract: We study mechanical dissipation of the fundamental mode of millimeter-sized, high quality-factor ($Q$) metalized silicon nitride membranes at temperatures down to 14 mK using a three-dimensional optomechanical cavity. Below 200 mK, high-$Q$ modes of the membranes show a diverging increase of $Q$ with decreasing temperature, reaching $Q=1.27\times10^8$ at 14 mK, an order of magnitude higher than re… ▽ More We study mechanical dissipation of the fundamental mode of millimeter-sized, high quality-factor ($Q$) metalized silicon nitride membranes at temperatures down to 14 mK using a three-dimensional optomechanical cavity. Below 200 mK, high-$Q$ modes of the membranes show a diverging increase of $Q$ with decreasing temperature, reaching $Q=1.27\times10^8$ at 14 mK, an order of magnitude higher than reported before. The ultra-low dissipation makes the membranes highly attractive for the study of optomechanics in the quantum regime, as well as for other applications of optomechanics such as microwave to optical photon conversion. △ Less

Submitted 11 January, 2016; v1 submitted 26 October, 2015; originally announced October 2015.

Comments: 12 pages, 4 figures

Journal ref: Applied Physics Letters, 107, 263501(2015)

Physical Effects of Distributed PV Generation on California's Distribution System

Authors: Michael A. Cohen, Duncan S. Callaway

Abstract: Deployment of high-penetration photovoltaic (PV) power is expected to have a range of effects -- both positive and negative -- on the distribution grid. The magnitude of these effects may vary greatly depending upon feeder topology, climate, PV penetration level, and other factors. In this paper we present a simulation study of eight representative distribution feeders in three California climates… ▽ More Deployment of high-penetration photovoltaic (PV) power is expected to have a range of effects -- both positive and negative -- on the distribution grid. The magnitude of these effects may vary greatly depending upon feeder topology, climate, PV penetration level, and other factors. In this paper we present a simulation study of eight representative distribution feeders in three California climates at PV penetration levels up to 100\%, supported by a unique database of distributed PV generation data that enables us to capture the impact of PV variability on feeder voltage and voltage regulating equipment. When comparing the influence of feeder location (i.e. climate) versus feeder type on outcomes, we find that location more strongly influences the incidence of reverse power flow, reductions in peak loading and the presence of voltage excursions. On the other hand, we find that feeder characteristics more strongly influence the magnitude of loss reduction and changes in voltage regulator operations. We find that secondary distribution transformer aging is negligibly affected in almost all scenarios. △ Less

Submitted 18 June, 2015; originally announced June 2015.

A Polynomial Approximation for Arbitrary Functions

Authors: Michael A. Cohen, Can Ozan Tan

Abstract: We describe an expansion of Legendre polynomials, analogous to the Taylor expansion, to approximate arbitrary functions. We show that the polynomial coefficients in Legendre expansion, therefore the whole series, converge to zero much more rapidly compared to the Taylor expansion of the same order. Furthermore, using numerical analysis using sixth-order polynomial expansion, we demonstrate that th… ▽ More We describe an expansion of Legendre polynomials, analogous to the Taylor expansion, to approximate arbitrary functions. We show that the polynomial coefficients in Legendre expansion, therefore the whole series, converge to zero much more rapidly compared to the Taylor expansion of the same order. Furthermore, using numerical analysis using sixth-order polynomial expansion, we demonstrate that the Legendre polynomial approximation yields an error at least an order of magnitude smaller than the analogous Taylor series approximation. This strongly suggests that Legendre expansions, instead of Taylor expansions, should be used when global accuracy is important. △ Less

Submitted 12 March, 2012; v1 submitted 2 August, 2011; originally announced August 2011.

Comments: 6 pages, 1 figure

MSC Class: 41A10; 65D15

Multiplicative Propagation of Error During Recursive Wavelet Estimation

Authors: Michael A. Cohen, Can Ozan Tan

Abstract: Wavelet coefficients are estimated recursively at progressively coarser scales recursively. As a result, the estimation is prone to multiplicative propagation of truncation errors due to quantization and round-off at each stage. Yet, the influence of this propagation on wavelet filter output has not been explored systematically. Through numerical error analysis of a simple, generic sub-band coding… ▽ More Wavelet coefficients are estimated recursively at progressively coarser scales recursively. As a result, the estimation is prone to multiplicative propagation of truncation errors due to quantization and round-off at each stage. Yet, the influence of this propagation on wavelet filter output has not been explored systematically. Through numerical error analysis of a simple, generic sub-band coding scheme with a half-band low pass finite impulse-response filter for down sampling, we show that truncation error in estimated wavelet filter coefficients can quickly reach unacceptable levels, and may render the results unreliable especially at coarser scales. △ Less

Submitted 28 July, 2011; originally announced July 2011.

Comments: 9 pages, 4 figures