-
High average power ultrafast laser technologies for driving future advanced accelerators
Authors:
Leily Kiani,
Tong Zhou,
Seung-Whan Bahk,
Jake Bromage,
David Bruhwiler,
E. Michael Campbell,
Zenghu Chang,
Enam Chowdhury,
Michael Downer,
Qiang Du,
Eric Esarey,
Almantas Galvanauskas,
Thomas Galvin,
Constantin Hafner,
Dieter Hoffmann,
Chan Joshi,
Manoj Kanskar,
Wei Lu,
Carmen Menoni,
Michael Messerly,
Sergey B. Mirov,
Mark Palmer,
Igor Pogorelsky,
Mikhail Polyanskiy,
Erik Power
, et al. (12 additional authors not shown)
Abstract:
Large scale laser facilities are needed to advance the energy frontier in high energy physics and accelerator physics. Laser plasma accelerators are core to advanced accelerator concepts aimed at reaching TeV electron electron colliders. In these facilities, intense laser pulses drive plasmas and are used to accelerate electrons to high energies in remarkably short distances. A laser plasma accele…
▽ More
Large scale laser facilities are needed to advance the energy frontier in high energy physics and accelerator physics. Laser plasma accelerators are core to advanced accelerator concepts aimed at reaching TeV electron electron colliders. In these facilities, intense laser pulses drive plasmas and are used to accelerate electrons to high energies in remarkably short distances. A laser plasma accelerator could in principle reach high energies with an accelerating length that is 1000 times shorter than in conventional RF based accelerators. Notionally, laser driven particle beam energies could scale beyond state of the art conventional accelerators. LPAs have produced multi GeV electron beams in about 20 cm with relative energy spread of about 2 percent, supported by highly developed laser technology. This validates key elements of the US DOE strategy for such accelerators to enable future colliders but extending best results to date to a TeV collider will require lasers with higher average power. While the per pulse energies envisioned for laser driven colliders are achievable with current lasers, low laser repetition rates limit potential collider luminosity. Applications will require rates of kHz to tens of kHz at Joules of energy and high efficiency, and a collider would require about 100 such stages, a leap from current Hz class LPAs. This represents a challenging 1000 fold increase in laser repetition rates beyond current state of the art. This whitepaper describes current research and outlook for candidate laser systems as well as the accompanying broadband and high damage threshold optics needed for driving future advanced accelerators.
△ Less
Submitted 2 May, 2022; v1 submitted 22 April, 2022;
originally announced April 2022.
-
Linear colliders based on laser-plasma accelerators
Authors:
C. Benedetti,
S. S. Bulanov,
E. Esarey,
C. G. R. Geddes,
A. J. Gonsalves,
A. Huebl,
R. Lehe,
K. Nakamura,
C. B. Schroeder,
D. Terzani,
J. van Tilborg,
M. Turner,
J. -L. Vay,
T. Zhou,
F. Albert,
J. Bromage,
E. M. Campbell,
D. H. Froula,
J. P. Palastro,
J. Zuegel,
D. Bruhwiler,
N. M. Cook,
B. Cros,
M. C. Downer,
M. Fuchs
, et al. (18 additional authors not shown)
Abstract:
White paper to the Proceedings of the U.S. Particle Physics Community Planning Exercise (Snowmass 2021): Linear colliders based on laser-plasma accelerators
White paper to the Proceedings of the U.S. Particle Physics Community Planning Exercise (Snowmass 2021): Linear colliders based on laser-plasma accelerators
△ Less
Submitted 4 July, 2022; v1 submitted 15 March, 2022;
originally announced March 2022.
-
Pump-Depletion Dynamics and Saturation of Stimulated Brillouin Scattering in Shock Ignition Relevant Experiments
Authors:
S. Zhang,
J. Li,
C. M. Krauland,
F. N. Beg,
S. Muller,
W. Theobald,
J. Palastro,
T. Filkins,
D. Turnbull,
D. Haberberger,
C. Ren,
R. Betti,
C. Stoeckl,
E. M. Campbell,
J. Trela,
D. Batani,
R. Scott,
M. S. Wei
Abstract:
As an alternative inertial confinement fusion scheme with predicted high energy gain and more robust designs, shock ignition requires a strong converging shock driven by a shaped pulse with a high-intensity spike at the end to ignite a pre-compressed fusion capsule. Understanding nonlinear laser-plasma instabilities in shock ignition conditions is crucial to assess and improve the laser-shock ener…
▽ More
As an alternative inertial confinement fusion scheme with predicted high energy gain and more robust designs, shock ignition requires a strong converging shock driven by a shaped pulse with a high-intensity spike at the end to ignite a pre-compressed fusion capsule. Understanding nonlinear laser-plasma instabilities in shock ignition conditions is crucial to assess and improve the laser-shock energy coupling. Recent experiments conducted on the OMEGA-EP laser facility have for the first time demonstrated that such instabilities can $\sim$100\% deplete the first 0.5 ns of the high-intensity laser pump. Analysis of the observed laser-generated blast wave suggests that this pump-depletion starts at 0.01--0.02 critical density and progresses to 0.1--0.2 critical density. This pump-depletion is also confirmed by the time-resolved stimulated Raman backscattering spectra. The dynamics of the pump-depletion can be explained by the breaking of ion-acoustic waves in stimulated Brillouin scattering. Such strong pump-depletion would inhibit the collisional laser energy absorption but may benefit the generation of hot electrons with moderate temperatures for electron shock ignition [Shang et al. Phys. Rev. Lett. 119 195001 (2017)].
△ Less
Submitted 30 August, 2019;
originally announced September 2019.
-
Direct-drive measurements of laser-imprint-induced shock velocity nonuniformities
Authors:
J. L. Peebles,
S. X. Hu,
W. Theobald,
V. N. Goncharov,
N. Whiting,
P. M. Celliers,
S. J. Ali,
G. Duchateau,
E. M. Campbell,
T. R. Boehly,
S. P. Regan
Abstract:
Perturbations in the velocity profile of a laser-ablation-driven shock wave seeded by speckle in the spatial beam intensity (i.e., laser imprint) have been measured. Direct measurements of these velocity perturbations were recorded using a two-dimensional high-resolution velocimeter probing plastic material shocked by a 100-ps picket laser pulse from the OMEGA laser system. The measured results fo…
▽ More
Perturbations in the velocity profile of a laser-ablation-driven shock wave seeded by speckle in the spatial beam intensity (i.e., laser imprint) have been measured. Direct measurements of these velocity perturbations were recorded using a two-dimensional high-resolution velocimeter probing plastic material shocked by a 100-ps picket laser pulse from the OMEGA laser system. The measured results for experiments with one, two, and five overlap** beams incident on the target clearly demonstrate a reduction in long-wavelength ($>$25 um) perturbations with an increasing number of overlap** laser beams, consistent with theoretical expectations. These experimental measurements are crucial to validate radiation-hydrodynamics simulations of laser imprint for laser direct drive inertial confinement fusion research since they highlight the significant (factor of 3) underestimation of the level of seeded perturbation when the microphysics processes for initial plasma formation, such as multiphoton ionization are neglected.
△ Less
Submitted 25 June, 2019;
originally announced June 2019.
-
Analysis of trends in experimental observables and reconstruction of the implosion dynamics for direct-drive cryogenic targets on OMEGA
Authors:
A. Bose,
R. Betti,
D. Mangino,
K. M. Woo,
D. Patel,
A. R. Christopherson,
V. Gopalaswamy,
O. M. Mannion,
S. P. Regan,
V. N. Goncharov,
D. H. Edgell,
C. J. Forrest,
J. A. Frenje,
M. Gatu Johnson,
V. Yu Glebov,
I. V. Igumenshchev,
J. P. Knauer,
F. J. Marshall,
P. B. Radha,
R. Shah,
C. Stoeckl,
W. Theobald,
T. C. Sangster,
D. Shvarts,
E. M. Campbell
Abstract:
This paper describes a technique for identifying trends in performance degradation for inertial confinement fusion implosion experiments. It is based on reconstruction of the implosion core with a combination of low- and mid-mode asymmetries. This technique was applied to an ensemble of hydro-equivalent deuterium-tritium implosions on OMEGA that achieved inferred hot-spot pressures ~56+/-7 Gbar [S…
▽ More
This paper describes a technique for identifying trends in performance degradation for inertial confinement fusion implosion experiments. It is based on reconstruction of the implosion core with a combination of low- and mid-mode asymmetries. This technique was applied to an ensemble of hydro-equivalent deuterium-tritium implosions on OMEGA that achieved inferred hot-spot pressures ~56+/-7 Gbar [S. Regan et al., Phys. Rev. Lett. 117, 025001 (2016)]. All the experimental observables pertaining to the core could be reconstructed simultaneously with the same combination of low and mid modes. This suggests that in addition to low modes, that can cause a degradation of the stagnation pressure, mid modes are present that reduce the size of the neuron and x-ray producing volume. The systematic analysis shows that asymmetries can cause an overestimation of the total areal density in these implosions. It is also found that an improvement in implosion symmetry resulting from correction of either the systematic mid or low modes would result in an increase of the hot-spot pressure from 56 Gbar to ~80 Gbar and could produce a burning plasma when the implosion core is extrapolated to an equivalent 1.9 MJ symmetric direct illumination [A. Bose et al., Phys. Rev. E 94, 011201(R) (2016)].
△ Less
Submitted 27 March, 2018;
originally announced March 2018.
-
Exploring magnetized liner inertial fusion with a semi-analytic model
Authors:
R. D. McBride,
S. A. Slutz,
R. A. Vesey,
M. R. Gomez,
A. B. Sefkow,
S. B. Hansen,
P. F. Knapp,
P. F. Schmit,
M. Geissel,
A. J. Harvey-Thompson,
C. A. Jennings,
E. C. Harding,
T. J. Awe,
D. C. Rovang,
K. D. Hahn,
M. R. Martin,
K. R. Cochrane,
K. J. Peterson,
G. A. Rochau,
J. L. Porter,
W. A. Stygar,
E. M. Campbell,
C. W. Nakhleh,
M. C. Herrmann,
M. E. Cuneo
, et al. (1 additional authors not shown)
Abstract:
In this paper, we explore magnetized liner inertial fusion (MagLIF) [S. A. Slutz et al., Phys. Plasmas 17, 056303 (2010)] using a semi-analytic model [R. D. McBride and S. A. Slutz, Phys. Plasmas 22, 052708 (2015)]. Specifically, we present simulation results from this model that: (a) illustrate the parameter space, energetics, and overall system efficiencies of MagLIF; (b) demonstrate the depende…
▽ More
In this paper, we explore magnetized liner inertial fusion (MagLIF) [S. A. Slutz et al., Phys. Plasmas 17, 056303 (2010)] using a semi-analytic model [R. D. McBride and S. A. Slutz, Phys. Plasmas 22, 052708 (2015)]. Specifically, we present simulation results from this model that: (a) illustrate the parameter space, energetics, and overall system efficiencies of MagLIF; (b) demonstrate the dependence of radiative loss rates on the radial fraction of the fuel that is preheated; (c) explore some of the recent experimental results of the MagLIF program at Sandia National Laboratories [M. R. Gomez et al., Phys. Rev. Lett. 113, 155003 (2014)]; (d) highlight the experimental challenges presently facing the MagLIF program; and (e) demonstrate how increases to the preheat energy, fuel density, axial magnetic field, and drive current could affect future MagLIF performance.
△ Less
Submitted 13 January, 2016; v1 submitted 25 November, 2015;
originally announced November 2015.
