Showing 1–7 of 7 results for author: Bacher, P

A step towards digital operations -- A novel grey-box approach for modelling the heat dynamics of Ultra-low temperature freezing chambers

Authors: Tao Huang, Peder Bacher, Jan Kloppenborg Møller, Francesco D'Ettorre, Wiebke Brix Markussen

Abstract: Ultra-low temperature (ULT) freezers store perishable bio-contents and have high energy consumption, which highlight a demand for reliable methods for intelligent surveillance and smart energy management. This study introduces a novel grey-box modelling approach based on stochastic differential equations to describe the heat dynamics of the ULT freezing chambers. The proposed modelling approach on… ▽ More Ultra-low temperature (ULT) freezers store perishable bio-contents and have high energy consumption, which highlight a demand for reliable methods for intelligent surveillance and smart energy management. This study introduces a novel grey-box modelling approach based on stochastic differential equations to describe the heat dynamics of the ULT freezing chambers. The proposed modelling approach only requires temperature data measured by the embedded sensors and uses data from the regular operation periods for model identification. The model encompasses three states: chamber temperature, envelope temperature, and local evaporator temperature. Special attention is given to the local evaporator temperature state, which is modelled as a time-variant system, to characterize the time delay and dynamic variations in cooling intensity. Two ULT freezers with different operational patterns are modelled. The unknown model parameters are estimated using the maximum likelihood method. The results demonstrate that the models can accurately predict the chamber temperature measured by the control probe (RMSE < 0.19 °C) and are promising to be applied for forecasting future states. In addition, the model for local evaporator temperature can effectively adapt to different operational patterns and provide insight into the local cooling supply status. The proposed approach greatly promotes the practical feasibility of grey-box modelling of the heat dynamics for ULT freezers and can serve several potential digital applications. A major limitation of the modelling approach is the low identifiability, which can potentially be addressed by inferring model parameters based on relative parameter changes. △ Less

Submitted 13 June, 2023; originally announced June 2023.

Estimation of Evaporator Valve Sizes in Supermarket Refrigeration Cabinets

Authors: Kenneth Leerbeck, Peder Bacher, Christian Heerup, Henrik Madsen

Abstract: In many applications, e.g. fault diagnostics and optimized control of supermarket refrigeration systems, it is important to determine the heat demand of the cabinets. This can easily be achieved by measuring the mass flow through each cabinet, however, that is expensive and not feasible in large-scale deployments. Therefore it is important to be able to estimate the valve sizes from the monitoring… ▽ More In many applications, e.g. fault diagnostics and optimized control of supermarket refrigeration systems, it is important to determine the heat demand of the cabinets. This can easily be achieved by measuring the mass flow through each cabinet, however, that is expensive and not feasible in large-scale deployments. Therefore it is important to be able to estimate the valve sizes from the monitoring data, which is typically measured. The valve size is measured by an area, which can be used to calculate mass flow through the valve -- this estimated value is referred to as the valve constant. A novel method for estimating the cabinet evaporator valve constants is proposed in the present paper. It is demonstrated using monitoring data from a refrigeration system in a supermarket consisting of data sampled at a one-minute sampling rate, however it is shown that a sampling time of around 10-20 minutes is adequate for the method. Through thermodynamic analysis of a two-stage CO2 refrigeration system, a linear regression model for estimating valve constants was developed using time series data. The linear regression requires that transient dynamics are not present in the data, which depends on multiple factors e.g. the sampling time. If dynamics are not modeled it can be detected by a significant auto-correlation of the residuals. In order to include the dynamics in the model, an Auto-Regressive Moving Average model with eXogenous variables (ARMAX) was applied, and it is shown how it effectively eliminates the auto-correlation and provides more unbiased estimates, as well as improved the accuracy estimates. Furthermore, it is shown that the sample time has a huge impact on the valve estimates. Thus, a method for selecting the optimal sampling time is introduced. It works individually for each of the evaporators, by exploring their respective frequency spectrum. △ Less

Submitted 21 February, 2022; originally announced February 2022.

Comments: Submitted to "Journal of Process Control"

onlineforecast: An R package for adaptive and recursive forecasting

Authors: Peder Bacher, Hjörleifur G. Bergsteinsson, Linde Frölke, Mikkel L. Sørensen, Julian Lemos-Vinasco, Jon Liisberg, Jan Kloppenborg Møller, Henrik Aalborg Nielsen, Henrik Madsen

Abstract: Systems that rely on forecasts to make decisions, e.g. control or energy trading systems, require frequent updates of the forecasts. Usually, the forecasts are updated whenever new observations become available, hence in an online setting. We present the R package onlineforecast that provides a generalized setup of data and models for online forecasting. It has functionality for time-adaptive fitt… ▽ More Systems that rely on forecasts to make decisions, e.g. control or energy trading systems, require frequent updates of the forecasts. Usually, the forecasts are updated whenever new observations become available, hence in an online setting. We present the R package onlineforecast that provides a generalized setup of data and models for online forecasting. It has functionality for time-adaptive fitting of dynamical and non-linear models. The setup is tailored to enable the effective use of forecasts as model inputs, e.g. numerical weather forecast. Users can create new models for their particular applications and run models in an operational setting. The package also allows users to easily replace parts of the setup, e.g. using neural network methods for estimation. The package comes with comprehensive vignettes and examples of online forecasting applications in energy systems, but can easily be applied for online forecasting in all fields. △ Less

Submitted 22 May, 2022; v1 submitted 27 September, 2021; originally announced September 2021.

Comments: 36 pages

MSC Class: 62-04 ACM Class: G.3

Journal ref: The R Journal, 15/1 (2023) 172-194

Control of heat pumps with CO2 emission intensity forecasts

Authors: Kenneth Leerbeck, Peder Bacher, Rune Grønborg, Anna Tveit, Olivier Corradi, Henrik Madsen

Abstract: An optimized heat pump control for building heating was developed for minimizing CO2 emissions from related electrical power generation. The control is using weather and CO2 emission forecasts as input to a Model Predictive Control (MPC) - a multivariate control algorithm using a dynamic process model, constraints and a cost function to be minimized. In a simulation study the control was applied u… ▽ More An optimized heat pump control for building heating was developed for minimizing CO2 emissions from related electrical power generation. The control is using weather and CO2 emission forecasts as input to a Model Predictive Control (MPC) - a multivariate control algorithm using a dynamic process model, constraints and a cost function to be minimized. In a simulation study the control was applied using weather and power grid conditions during a full year period in 2017-2018 for the power bidding zone DK2 (East, Denmark). Two scenarios were studied; one with a family house and one with an office building. The buildings were dimensioned on the basis of standards and building codes. The main results are measured as the CO2 emission savings relative to a classical thermostatic control. Note that this only measures the gain achieved using the MPC control, i.e. the energy flexibility, not the absolute savings. The results show that around 16% savings could have been achieved during the period in well insulated new buildings with floor heating. Further, a sensitivity analysis was carried out to evaluate the effect of various building properties, e.g. level of insulation and thermal capacity. Danish building codes from 1977 and forward was used as benchmarks for insulation levels. It was shown that both insulation and thermal mass influence the achievable flexibility savings, especially for floor heating. Buildings that comply with codes later than 1979 could provide flexibility emission savings of around 10%, while buildings that comply with earlier codes provided savings in the range of 0-5% depending on the heating system and thermal mass. △ Less

Submitted 11 May, 2020; originally announced May 2020.

Comments: 16 pages, 12 figures. Submitted to Energies

Short-Term Forecasting of CO2 Emission Intensity in Power Grids by Machine Learning

Authors: Kenneth Leerbeck, Peder Bacher, Rune Junker, Goran Goranović, Olivier Corradi, Razgar Ebrahimy, Anna Tveit, Henrik Madsen

Abstract: A machine learning algorithm is developed to forecast the CO2 emission intensities in electrical power grids in the Danish bidding zone DK2, distinguishing between average and marginal emissions. The analysis was done on data set comprised of a large number (473) of explanatory variables such as power production, demand, import, weather conditions etc. collected from selected neighboring zones. Th… ▽ More A machine learning algorithm is developed to forecast the CO2 emission intensities in electrical power grids in the Danish bidding zone DK2, distinguishing between average and marginal emissions. The analysis was done on data set comprised of a large number (473) of explanatory variables such as power production, demand, import, weather conditions etc. collected from selected neighboring zones. The number was reduced to less than 50 using both LASSO (a penalized linear regression analysis) and a forward feature selection algorithm. Three linear regression models that capture different aspects of the data (non-linearities and coupling of variables etc.) were created and combined into a final model using Softmax weighted average. Cross-validation is performed for debiasing and autoregressive moving average model (ARIMA) implemented to correct the residuals, making the final model the variant with exogenous inputs (ARIMAX). The forecasts with the corresponding uncertainties are given for two time horizons, below and above six hours. Marginal emissions came up independent of any conditions in the DK2 zone, suggesting that the marginal generators are located in the neighbouring zones. The developed methodology can be applied to any bidding zone in the European electricity network without requiring detailed knowledge about the zone. △ Less

Submitted 10 March, 2020; originally announced March 2020.

Comments: 15 pages and 11 figures including appendix. Submitted to Applied Energy (Elsevier)

Primary and secondary anti-viral response captured by the dynamics and phenotype of individual T cell clones

Authors: Anastasia A. Minervina, Mikhail V. Pogorelyy, Ekaterina A. Komech, Vadim K. Karnaukhov, Petra Bacher, Elisa Rosati, Andre Franke, Dmitriy M. Chudakov, Ilgar Z. Mamedov, Yuri B. Lebedev, Thierry Mora, Aleksandra M. Walczak

Abstract: The diverse repertoire of T-cell receptors (TCR) plays a key role in the adaptive immune response to infections. Previous studies show that secondary responses to the yellow fever vaccine - the model for acute infection in humans - are weaker than primary ones, but only quantitative measurements can describe the concentration changes and lineage fates for distinct T-cell clones in vivo over time.… ▽ More The diverse repertoire of T-cell receptors (TCR) plays a key role in the adaptive immune response to infections. Previous studies show that secondary responses to the yellow fever vaccine - the model for acute infection in humans - are weaker than primary ones, but only quantitative measurements can describe the concentration changes and lineage fates for distinct T-cell clones in vivo over time. Using TCR alpha and beta repertoire sequencing for T-cell subsets, as well as single-cell RNAseq and TCRseq, we track the concentrations and phenotypes of individual T-cell clones in response to primary and secondary yellow fever immunization showing their large diversity. We confirm the secondary response is an order of magnitude weaker, albeit $\sim10$ days faster than the primary one. Estimating the fraction of the T-cell response directed against the single immunodominant epitope, we identify the sequence features of TCRs that define the high precursor frequency of the two major TCR motifs specific for this particular epitope. We also show the consistency of clonal expansion dynamics between bulk alpha and beta repertoires, using a new methodology to reconstruct alpha-beta pairings from clonal trajectories. △ Less

Submitted 3 March, 2020; v1 submitted 25 October, 2019; originally announced October 2019.

Journal ref: eLife 2020;9:e53704 (2020)

Load Forecasting of Supermarket Refrigeration

Authors: Lisa Buth Rasmussen, Peder Bacher, Henrik Madsen, Henrik Aalborg Nielsen, Christian Heerup, Torben Green

Abstract: This paper presents a study of models for forecasting the electrical load for supermarket refrigeration. The data used for building the models consists of load measurements, local climate measurements and weather forecasts. The load measurements are from a supermarket located in a village in Denmark. Every hour the hourly electrical load for refrigeration is forecasted for the following 42 hours.… ▽ More This paper presents a study of models for forecasting the electrical load for supermarket refrigeration. The data used for building the models consists of load measurements, local climate measurements and weather forecasts. The load measurements are from a supermarket located in a village in Denmark. Every hour the hourly electrical load for refrigeration is forecasted for the following 42 hours. The forecast models are adaptive linear time series models. The model has two regimes; one for opening hours and one for closing hours, this is modelled by a regime switching model and two different methods for predicting the regimes are tested. The dynamic relation between the weather and the load is modelled by simple transfer functions and the non-linearities are described using spline functions. The results are thoroughly evaluated and it is shown that the spline functions are suitable for handling the non-linear relations and that after applying an auto-regressive noise model the one-step ahead residuals do not contain further significant information. △ Less

Submitted 23 June, 2014; originally announced June 2014.