-
Scaling slowly rotating asteroids by stellar occultations
Authors:
A. Marciniak,
J. Ďurech,
A. Choukroun,
J. Hanuš,
W. Ogłoza,
R. Szakáts,
L. Molnár,
A. Pál,
F. Monteiro,
E. Frappa,
W. Beisker,
H. Pavlov,
J. Moore,
R. Adomavičienė,
R. Aikawa,
S. Andersson,
P. Antonini,
Y. Argentin,
A. Asai,
P. Assoignon,
J. Barton,
P. Baruffetti,
K. L. Bath,
R. Behrend,
L. Benedyktowicz
, et al. (154 additional authors not shown)
Abstract:
As evidenced by recent survey results, majority of asteroids are slow rotators (P>12 h), but lack spin and shape models due to selection bias. This bias is skewing our overall understanding of the spins, shapes, and sizes of asteroids, as well as of their other properties. Also, diameter determinations for large (>60km) and medium-sized asteroids (between 30 and 60 km) often vary by over 30% for m…
▽ More
As evidenced by recent survey results, majority of asteroids are slow rotators (P>12 h), but lack spin and shape models due to selection bias. This bias is skewing our overall understanding of the spins, shapes, and sizes of asteroids, as well as of their other properties. Also, diameter determinations for large (>60km) and medium-sized asteroids (between 30 and 60 km) often vary by over 30% for multiple reasons.
Our long-term project is focused on a few tens of slow rotators with periods of up to 60 hours. We aim to obtain their full light curves and reconstruct their spins and shapes. We also precisely scale the models, typically with an accuracy of a few percent.
We used wide sets of dense light curves for spin and shape reconstructions via light-curve inversion. Precisely scaling them with thermal data was not possible here because of poor infrared data: large bodies are too bright for WISE mission. Therefore, we recently launched a campaign among stellar occultation observers, to scale these models and to verify the shape solutions, often allowing us to break the mirror pole ambiguity.
The presented scheme resulted in shape models for 16 slow rotators, most of them for the first time. Fitting them to stellar occultations resolved previous inconsistencies in size determinations. For around half of the targets, this fitting also allowed us to identify a clearly preferred pole solution, thus removing the ambiguity inherent to light-curve inversion. We also address the influence of the uncertainty of the shape models on the derived diameters.
Overall, our project has already provided reliable models for around 50 slow rotators. Such well-determined and scaled asteroid shapes will, e.g. constitute a solid basis for density determinations when coupled with mass information. Spin and shape models continue to fill the gaps caused by various biases.
△ Less
Submitted 13 October, 2023;
originally announced October 2023.
-
Properties of slowly rotating asteroids from the Convex Inversion Thermophysical Model
Authors:
A. Marciniak,
J. Ďurech,
V. Alí-Lagoa,
W. Ogłoza,
R. Szakáts,
T. G. Müller,
L. Molnár,
A. Pál,
F. Monteiro,
P. Arcoverde,
R. Behrend,
Z. Benkhaldoun,
L. Bernasconi,
J. Bosch,
S. Brincat,
L. Brunetto,
M. Butkiewicz - Bąk,
F. Del Freo,
R. Duffard,
M. Evangelista-Santana,
G. Farroni,
S. Fauvaud,
M. Fauvaud,
M. Ferrais,
S. Geier
, et al. (51 additional authors not shown)
Abstract:
Results from the TESS mission showed that previous studies strngly underestimated the number of slow rotators, revealing the importance of studying those asteroids. For most slowly rotating asteroids (P > 12), no spin and shape model is available because of observation selection effects. This hampers determination of their thermal parameters and accurate sizes.
We continue our campaign in minimi…
▽ More
Results from the TESS mission showed that previous studies strngly underestimated the number of slow rotators, revealing the importance of studying those asteroids. For most slowly rotating asteroids (P > 12), no spin and shape model is available because of observation selection effects. This hampers determination of their thermal parameters and accurate sizes.
We continue our campaign in minimising selection effects among main belt asteroids. Our targets are slow rotators with low light-curve amplitudes. The goal is to provide their scaled spin and shape models together with thermal inertia, albedo, and surface roughness to complete the statistics. Rich multi-apparition datasets of dense light curves are supplemented with data from Kepler and TESS. In addition to data in the visible range, we also use thermal data from infrared space observatories (IRAS, Akari and WISE) in a combined optimisation process using the Convex Inversion Thermophysical Model (CITPM). This novel method has so far been applied to only a few targets, and in this work we further validate the method.
We present the models of 16 slow rotators. All provide good fits to both thermal and visible data. The obtained sizes are on average accurate at the 5% precision, with diameters in the range from 25 to 145 km. The rotation periods of our targets range from 11 to 59 hours, and the thermal inertia covers a wide range of values, from 2 to <400 SI units, not showing any correlation with the period. With this work we increase the sample of slow rotators with reliable spin and shape models and known thermal inertia by 40%. The thermal inertia values of our sample do not display a previously suggested increasing trend with rotation period, which might be due to their small skin depth.
△ Less
Submitted 1 September, 2021;
originally announced September 2021.
-
Thermal properties of slowly rotating asteroids: Results from a targeted survey
Authors:
A. Marciniak,
V. Alí-Lagoa,
T. G. Müller,
R. Szakáts,
L. Molnár,
A. Pál,
E. Podlewska - Gaca,
N. Parley,
P. Antonini,
E. Barbotin,
R. Behrend,
L. Bernasconi,
M. Butkiewicz - Bąk,
R. Crippa,
R. Duffard,
R. Ditteon,
M. Feuerbach,
S. Fauvaud,
J. Garlitz,
S. Geier,
R. Goncalves,
J. Grice,
I. Grześkowiak,
R. Hirsch,
J. Horbowicz
, et al. (29 additional authors not shown)
Abstract:
Context. Earlier work suggests that slowly rotating asteroids should have higher thermal inertias than faster rotators because the heat wave penetrates deeper into the sub-surface. However, thermal inertias have been determined mainly for fast rotators due to selection effects in the available photometry used to obtain shape models required for thermophysical modelling (TPM).
Aims. Our aims are…
▽ More
Context. Earlier work suggests that slowly rotating asteroids should have higher thermal inertias than faster rotators because the heat wave penetrates deeper into the sub-surface. However, thermal inertias have been determined mainly for fast rotators due to selection effects in the available photometry used to obtain shape models required for thermophysical modelling (TPM).
Aims. Our aims are to mitigate these selection effects by producing shape models of slow rotators, to scale them and compute their thermal inertia with TPM, and to verify whether thermal inertia increases with the rotation period.
Methods. To decrease the bias against slow rotators, we conducted a photometric observing campaign of main-belt asteroids with periods longer than 12 hours, from multiple stations worldwide, adding in some cases data from WISE and Kepler space telescopes. For spin and shape reconstruction we used the lightcurve inversion method, and to derive thermal inertias we applied a thermophysical model to fit available infrared data from IRAS, AKARI, and WISE.
Results. We present new models of 11 slow rotators that provide a good fit to the thermal data. In two cases, the TPM analysis showed a clear preference for one of the two possible mirror solutions. We derived the diameters and albedos of our targets in addition to their thermal inertias, which ranged between 3$^{+33}_{-3}$ and 45$^{+60}_{-30}$ Jm$^{-2}$s$^{-1/2}$K$^{-1}$.
Conclusions. Together with our previous work, we have analysed 16 slow rotators from our dense survey with sizes between 30 and 150 km. The current sample thermal inertias vary widely, which does not confirm the earlier suggestion that slower rotators have higher thermal inertias.
△ Less
Submitted 15 May, 2019;
originally announced May 2019.
-
Photometric survey, modelling, and scaling of long-period and low-amplitude asteroids
Authors:
A. Marciniak,
P. Bartczak,
T. Müller,
J. J. Sanabria,
V. Alí-Lagoa,
P. Antonini,
R. Behrend,
L. Bernasconi,
M. Bronikowska,
M. Butkiewicz - Bąk,
A. Cikota,
R. Crippa,
R. Ditteon,
G. Dudziński,
R. Duffard,
K. Dziadura,
S. Fauvaud,
S. Geier,
R. Hirsch,
J. Horbowicz,
M. Hren,
L. Jerosimic,
K. Kamiński,
P. Kankiewicz,
I. Konstanciak
, et al. (18 additional authors not shown)
Abstract:
The available set of spin and shape modelled asteroids is strongly biased against slowly rotating targets and those with low lightcurve amplitudes. As a consequence of these selection effects, the current picture of asteroid spin axis distribution, rotation rates, or radiometric properties, might be affected too.
To counteract these selection effects, we are running a photometric campaign of a l…
▽ More
The available set of spin and shape modelled asteroids is strongly biased against slowly rotating targets and those with low lightcurve amplitudes. As a consequence of these selection effects, the current picture of asteroid spin axis distribution, rotation rates, or radiometric properties, might be affected too.
To counteract these selection effects, we are running a photometric campaign of a large sample of main belt asteroids omitted in most previous studies. We determined synodic rotation periods and verified previous determinations. When a dataset for a given target was sufficiently large and varied, we performed spin and shape modelling with two different methods.
We used the convex inversion method and the non-convex SAGE algorithm, applied on the same datasets of dense lightcurves. Unlike convex inversion, the SAGE method allows for the existence of valleys and indentations on the shapes based only on lightcurves.
We obtained detailed spin and shape models for the first five targets of our sample: (159) Aemilia, (227) Philosophia, (329) Svea, (478) Tergeste, and (487) Venetia. When compared to stellar occultation chords, our models obtained an absolute size scale and major topographic features of the shape models were also confirmed. When applied to thermophysical modelling, they provided a very good fit to the infrared data and allowed their size, albedo, and thermal inertia to be determined.
Convex and non-convex shape models provide comparable fits to lightcurves. However, some non-convex models fit notably better to stellar occultation chords and to infrared data in sophisticated thermophysical modelling (TPM). In some cases TPM showed strong preference for one of the spin and shape solutions. Also, we confirmed that slowly rotating asteroids tend to have higher-than-average values of thermal inertia.
△ Less
Submitted 6 November, 2017;
originally announced November 2017.
